79-041 (Type 1) Black and Decker Workbench - Overview

This is a genuine Black and Decker replacement part, it is sold individually. The foot is used on all of the workmates shown below. There are four per unit. The purpose of the foot is to keep the unit stable and keep it from moving on the surface it is placed on. It attaches the 242415-02 Leg.

Genuine Black and Decker replacement part, it is sold individually. This part is used on all the Workmates shown below Its purpose is to open and close the front and rear Vise Jaws on the Workmates. It is held to the vise screw by means of roll pin.

This is a genuine Black and Decker replacement part, it is sold individually. The foot is used on all of the workmates shown below. There are four per unit. The purpose of the foot is to keep the unit stable and keep it from moving on the surface it is placed on.

This is a genuine Black and Decker replacement part, it is sold individually. The Snap-In Knob is installed in the 242302-00 Crank Handle, on the list of Wormates shown below. Its purpose is to rotate the crank vise to open or close the vise jaws.

This is a genuine Black and Decker replacement part. It is sold Individually. The part will hold the leg on the Workmate in the down position and lock it in place. By releasing this part the leg can be raised back into the up position.

This is a genuine manufacturer sourced replacement part. It is specially designed for use with workmate work benches. Its purpose it to help securing the crank arm to the vise screw. This item is made out of metal and it is sold individually. Normally you should be able to pull out the old roll pin using a pair of pliers.

This is a standard bolt which has multiple uses based on your equipment. It is supplied by original equipment manufacturer. Please refer to diagrams of your unit for correct application of this hardware. It is a hex head bolt and it is sold individually. When installing or removing this bolt you would need a wrench.

This axle is an original Black and Decker replacement part manufactured for use with workmate workbenches. The special axle is used as a pin to secure the legs, and allow them to pivot or fold for storage. This axle is sold individually.

This is a genuine DeWALT replacement part. This item is constructed of durable metal, and is compatible with several Workmate and Work Center tables. Legs are fastened onto the four sides of the table base, with foot boots secured on the leg ends. A screwdriver may be needed to remove and replace the leg. This part is sold individually.

This is a genuine manufacturer-approved part which is specially designed for use with DeWALT and Black and Decker equipment. It is an identical replacement for a missing or faulty tension spring that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and applic...Read moreation of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.