71322 (ASWCSE2) LG Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
old bushing worn and broken
23 of 43 people
found this instruction helpful.
-
Jerry from CORSICANA, TX
- Really Easy
- 30 - 60 mins
-
Screw drivers, Socket set
removed the upper freezer door to access screws to remove lower door.
laid bottom door on its side, removed bad bushing, put new bushing in, put bottom door back on refridge, put upper door back on fridge. Door worked easy as when new. good closure of door and story..Happy customer, and wife even happier.....thank you....
laid bottom door on its side, removed bad bushing, put new bushing in, put bottom door back on refridge, put upper door back on fridge. Door worked easy as when new. good closure of door and story..Happy customer, and wife even happier.....thank you....
Was this helpful?
Thank you for voting!
Error Code dH F
13 of 26 people
found this instruction helpful.
-
Garthlette from COVINGTON, GA
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
The refrigerator had the above code and when I check on YouTube, it explained that the defrosting was not working properly. It was taking more than 80 minutes to defrost. I ordered the Temperature Sensor first and it was not the issue. I also ordered the Defrost Temperature fuse or the Thermistor. I had to defrost the refrigerator first
... Read more
by using a portable heater to get it done quickly. (See Youtube on how to get to the Defrosting Unit inside the freezer). The Thermistor was the wrong part. I called the Partselect and explained that the part with the heating element is one piece. (Heating Coil Thermistor or Heating Coil). By replacing that piece solved the Error Code issue. I listened to Youtube for the instructions on how to replace the Heater Coil. So if you see the Error Code dH F, you need to replace the Heating Coil, which comes in
one piece and sits on the bottom of the Defrost Element.
one piece and sits on the bottom of the Defrost Element.
Read less
Was this helpful?
Thank you for voting!
bottom door dropped slightly and bottom hinge area rubbing on steel door support
12 of 27 people
found this instruction helpful.
-
Louis from PHILADELPHIA, PA
- Really Easy
- 30 - 60 mins
-
Screw drivers, Socket set, Wrench set
removed 3 fasteners for top door and placed freezer door aside, then removed 3 more fasteners on bottom refrigerator door and place that aside. replaced bushing on lower door bracket and reversed the above procedure to reinstall doors.
Was this helpful?
Thank you for voting!
Freezer frost accumulation
3 of 5 people
found this instruction helpful.
-
Peter from Sewell, NJ
- Easy
- 30 - 60 mins
-
Screw drivers
After noting frost in freezer Right rail started to jam. Noted freezer door was closing crooked. Rail replacement resolved issue. It had been frosting up for some time so Rail must have been broken for a while. Check door seals they were not closing flush.
Was this helpful?
Thank you for voting!
water leaking from where line goes into icemaker in back of refrigerator.
1 person
found this instruction helpful.
-
Daniel from CLARENCE CTR, NY
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Screw drivers
The old valve must of had a slow leak and ice built up at icemaker. Make sure you clear ice from line at that point before turning on icemaker.
Was this helpful?
Thank you for voting!
Frig door not closing on its own accompanied by grinding sound
1 of 6 people
found this instruction helpful.
-
Joseph from Pennsville, NJ
- Really Easy
- 15 - 30 mins
-
Screw drivers, Socket set
IMPORTANT: REPAIR EASIER WITH ASSISTANT! Pull frig from kitchen cabinets & unplug. Remove food from freezer & frig doors. Have assistant hold freezer door closed against freezer. Remove hinge cap from top of freezer along with hardware using socket wrench. Carefully lift freezer door from hardware that joins the bottom of the freezer door
... Read more
to the top of the frig door. Rest freezer door upright off to the side. Have assistant open frig door & SUPPORT BOTTOM. Remove hardware from top of frig using crescent wrench & screwdriver. Carefully lift frig door off joint & lay on side to gain access to hardware on bottom. Remove hardware using a screwdriver & replace worn nylon bushing. Reverse disassembly steps. Remove frig & freezer door shelves & clean inside. Clean outside frig, especially the back vents. Clean the floor where frig lives & push back into place. Enjoy clean SELF-CLOSING, NON-GRINDING frig door!
Read less
Was this helpful?
Thank you for voting!
Water/ice maker not working
9 of 37 people
found this instruction helpful.
-
Brent from ROGERS, MN
- Really Easy
- Less than 15 mins
-
Screw drivers
Remove push plate for water/ice maker switch, remove 2 screws and 2 wires for switch. Replace with new.
Was this helpful?
Thank you for voting!