7063173 Snapper Lawn Tractor - Overview

The hair pin is a silver, metal pin used to secure and lock parts in place. If broken, the part being secured will come loose and the pin should be replaced. This is an OEM part directly from the manufacturer. Most customers rated the replacement of the hair pin as an easy repair.

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

This 5/16 washer, or toothed washer, is sold individually. It provides a tight fit between the knob and the upper handle on a range of outdoor power equipment. It attaches between the wing knob and the upper handle, and over time and through use, can become damaged and need replacing. It is gold in color and metal, and repairing it is an easy task according to our customers.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This hex center lock nut is sourced from the original manufacturer for use in lawn and garden power equipment. It is a hexagon-shaped fastener for bolts/studs that is responsible for the keeping the bolt/studs secure during use. The nut is made of metal and has a diameter of 5/16 of an inch and a thread pitch of 18 internal threads per in...Read morech. Over time the threads in the nut can wear down and the nut itself may crack or break. It is important to replace it as soon as necessary to avoid damaging your equipment. Use a socket or wrench to remove the old nut and thread the new one on. Make sure to order the correct number of nuts for your equipment as each nut is sold individually.

Decal snapper

It is an authentic OEM sourced item which is specially produced for use with snowthrowers, generators, and rear engine riders made by Murray, Briggs & Stratton, Snapper, and Simplicity. The nut is made of metal and attaches to the starter switch. During replacement, it may require a wrench to help install this part correctly. It may becom...Read moree broken or stripped and will need to be replaced. This part is available as an individual replacement.

Pin 5/16-x1.68

Ohms 5/16f

This 3/8C hex nut, which helps secure parts in place, is gold in color, made of metal, and sold individually. This part can be used on a variety of equipment, so check with your owners manual or model number to ensure it is the nut you need. You will know it needs replacing when the threads are damaged or its ends are rounded off, causing...Read more the nut to longer be able to tighten or loosen. It is a repair our customers find easy, and just requires a wrench or socket and torque wrench to complete.

Lockwasher split 3/8