7000GBS Waring Blender - Overview

This is a genuine manufacturer sourced replacement part used on Waring blenders. The coupling is the part of a blender that transfers power from the blender's motor to the blade assembly. Over time, the teeth on blender coupling wear down until they no longer engage properly on the blade assembly. It is made out of plastic and it is sold individually.

This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.

This is a Genuine OEM sourced replacement part designed for use with Waring Blenders. This is the Blade that cuts food inside the container. It is made out of Metal and it is Sold Individually. To replace it you would need a Wrench or Pliers. • First you want to remove the Nut that secures the old blade assembly • Remove the cutte...Read morer assembly and make sure to clean the gaskets • Secure the new blade assembly using the Nut

Waring Pro has manufactured this Coupling for many models of blenders. This Coupling is used to drive the blades in the blender jar. To remove this part you will need to hold the blade in place and turn the coupling counter clockwise. The flat side of the coupling needs to install facing the bearing. The Coupling can also be purchased included in the Blending Assembly (part number 007314W).

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is an authentic manufacturer sourced replacement part used on Waring blenders. Jar assembly locks into the blender base and holds the foods and liquids being blended. This container is made out of glass and it is sold individually.