6940DWA Makita Impact Driver - Overview

Genuine Makita replacement part, this item is sold individually. This part is used on the tools listed below, to contain all of the part that are attached to the front end of the tool. Such as the Chuck assemblies on the the Impact Drivers and the Spindle Assemblies on the Screwdrivers.

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.

This is a Genuine OEM Sourced replacement part designed for Makita Impact Drivers. This part is made out of Metal and it is Sold Individually. This Washer helps to provide seal for the Sleeve. When replacing this part you would need a Screwdriver and Pliers.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.

This is a Genuine OEM replacement part used on Makita drills and drivers. This is a metal spring and it is sold individually. Over time springs may lose its tension and may not function as intended. If this part is lost or damaged it must be replaced. To replace this spring a pair of pliers is needed.