690 (ALL TYPES) Porter Cable Router - Overview

Genuine OEM Replacement Part used on a variety of Power Equipment. This part is made out of Metal and is Sold Individually. Terminal Eyelet allows you to safely and easily secure a wire to the needed part of the tool using only a screw.

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on t...Read morehe tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This leaf-type spring (also called a flat spring) is sold individually. It is an authentic Porter Cable replacement part.

This brush is a genuine Porter-Cable replacement part, not generic. As pictured, this brush is ready to install and includes carbon brush, wire lead, and spring. This item is sold individually. Over time, brushes will wear down and eventually require replacement. This brush will fit the models listed in the 'Compatibility' section belo...Read morew. It is not guaranteed to fit any other power tool models. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor’s electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This is a genuine Porter Cable replacement part, it is sold individually. A Cord Strain Reliever is used on most all power tools. It purpose is to reduce the bending of the cord as it comes out of the housing, which otherwise would cause the cord to crack and wear.

This is an authentic OEM part. The Porter Cable knob is compatible with many router devices. The threaded metal with a plastic grip is fitted in the edge guide assembly, securing the edge guide rod. This component is sold individually, and no tools are required for the replacement.

This replacement sub base is an authentic manufacturer approved item. It is supplied directly from original equipment manufacturer for use with routers. This is the base plate that allows the tool to slide smoothly over the work surface. This part is made out of black plastic and it is sold individually. This is a simple repair that shou...Read moreld only require a screwdriver. • Remove the four (4) screws that secure the sub base • Remove the old plate and replace it with a new one • Secure the new plate using the four (4) screws

Genuine OEM replacement part, this item is sold individually. The 874582 Clamp Knob is used to tighten the bases of all of the Routers shown below. It is used with part number 695526 Screw, to clamp the Router Motor in the base for the desired height of the motor.

This is a flat washer compatible with various types of power tools, including routers. The washer has an approximate outer diameter of 5mm and is constructed from metal. It plays a crucial role in securing various components on the router or tool to which it is attached. If you observe that the washer is missing, damaged, broken, or warpe...Read mored, it is essential to replace it promptly to prevent potential damage to other parts or the tool, appliance, or engine itself. This OEM washer is sold individually and does not include any additional accessories.

Genuine OEM replacement part, this item is sold individually. The 685526 Screw is used to tighten the bases of all of the Routers shown below. It is used with part number 874582 Clamp Knob, to clamp the Router Motor in the base for the desired height of the motor.

Does not include the screw, washer, or clamp knob.