6801DBV (Type 2) Makita Screwdriver - Overview

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually re...Read morequire replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls re...Read moreduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This is a Ball Bearing that is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwise spin and rub against each other. The balls or rollers take the load and spin, distributing the weight evenly while the minimal co...Read morentact area of the balls reduce friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Genuine Makita replacement part. This phillips pan-head screw includes a washer. It is sold individually.

This is a genuine OEM replacement part manufactured for use with Makita power tools. The hexagonal nut is used with several different types of equipment and the application of the nut can vary based on the model of the power tool. This hex nut is available as an individual replacement part.

This Woodruff key 3 is an OEM part direct from the Makita manufacturer. Constructed of durable metal, the key is designed for use with a variety of power tools. Woodruff keys help to prevent rotation between designated engine parts. Please be sure to refer to specific manual and diagrams for repair instructions. This component is sold ind...Read moreividually. A screwdriver and a wrench are often necessary for the removal and replacement.

This 5 x 8 carbon brush holder is a genuine OEM replacement part used in various outdoor power equipment. It is a small plastic box with a cavity, and it is located near the engine assembly. The brush holder is responsible for holding and making electrical contact with the carbon brushes. The carbon brushes provide electrical current to t...Read morehe moving parts of the equipment. A faulty carbon brush holder will lead to reduced power output or complete loss of power. You will notice difficulties starting the engine, and the equipment may shut off during use. To begin the repair, first disconnect the power source. Remove the motor housing cover to access the holder and release the old brushes. Attach the new holder in place and reinsert the carbon brushes. Reassemble your equipment and switch it back on to check for functionality. Each brush holder is sold individually.