My Orders
6651336580 Kenmore Trash Compactor - Overview
Diagrams for 6651336580
See every part. Know exactly what you need.
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
$77.75
In Stock
Drive Gear Kit
Part #882699
This is the drive gear kit for the ram that compacts the trash inside your compactor. If your compactor ram is getting stuck, there is excess noise during its cycle, or if your compactor does not stop at the end of its cycle, the driving gear may be the issue. The gear is white, plastic and approximately 4.5 inches in diameter. This drive...Read more gear kit includes both gears, pin spring, retaining clip (c-ring), ram stop, ram cam, and instructions. Make sure to disconnect the power to your trash compactor before beginning the repair.
Read less
$7.47
In Stock
$6.40
In Stock
Washer Front Leveling Foot
Part #WPW10001130
The front facing foot is sold individually. It is used on your washing machine and can also be known as an adjustable leveling leg. This specific front facing leveling leg has a rubber foot. It is important that when installing this part you are very careful, if not installed correctly your washer will be off balance which will then cause...Read more it to vibrate and/or shake during the cycle. The function of the adjustable foot is to keep your washing machine supported and to make sure that it is level at all times. The tools you will need for this repair include a pair of channel lock pliers, and a 9/16 wrench.
Read less
$57.38
In Stock
Trash Compactor Directional Switch
Part #WP777811
The function of the directional switch on your trash compactor is to ensure the ram lowers to compress your trash then returns to the top position. If your trash compactor does not complete this task will not stop at the end of the compacting cycle or is noisy during operation you may need to replace the directional switch. Be sure to dis...Read moreconnect your trash compactor from the power source before completing this repair. This is a fairly easy repair. After you open the control panel of the compactor all you will need to do is unplug the old switch from the electrical wires and plug the new switch in.
Read less
$97.57
In Stock
Rotary Switch Kit
Part #675382
The rotary switch kit is also known as the start switch or the on and off switch, and is used to power on your trash compactor. The function of the rotary switch kit is to control the electrical power that is going into your trash compactor. This process happens when the switch sendsvoltage to the motor to start the compacting cycle. If y...Read moreour switch is broken the trash compactor will not start. A multimeter test can be performed to test the switch for continuity. The rotary switch kit will come with an on and off rotary switch, and two chrome knobs.
Read less
$7.47
In Stock
$47.40
On Order
Power Nut
Part #WP777533
This part is a power nut, and it is intended to be used in conjunction with trash compactors. The function of this nut is to fasten to the side of the ram where it is threaded. When the power screw rotates, it is fed through the power nut, which pulls the ram down to compress the trash. This part is just over an inch in diameter, and is j...Read moreust one inch thick. This part is white and made entirely of plastic. The reason for needing to replace this part is if your compactor ram gets stuck, or if it does not stop at the end of the compacting cycle.
Read less
$17.15
In Stock
Drawer Roller
Part #WP9871602
This bearing roller may also be known as the wheel assembly or the container roller bearing, and it is a piece for your trash bin. The function of this bearing is to work in conjunction with your trash bin to allow the canister to roll free. For this repair you will need a nut driver, a pair of pliers, a screwdriver set, and an adjustable...Read more wrench. The most obvious symptom that will require you to replace this part is if your drawer is hard to open and/or close. Your appliance comes with two bearing rollers and it is sold individually.
Read less
$27.36
In Stock
Wheel Assembly - Kit of 2
Part #882688
This wheel assembly, or roller assembly, is for a trash compactor. The kit includes two wheels that are approximately 1 inch in diameter each. The wheels allow the trash compactor container to roll in and out of the appliance. You may have to replace the wheel assembly if the container does not roll smoothly. To access the existing wheel ...Read morekit on your appliance, uninstall appliance from the cabinet, depress foot petal to lift the container off its track, and remove the container from the tracks. This kit is an OEM part sourced from the authentic manufacturer factory.
Read less
$105.46
On Order
$7.47
In Stock
$11.77
Special Order
Common Symptoms of the 6651336580
How this model fails, and the parts that fix it.
Doesn’t stop at end of compacting cycle
Fixed by
these parts
these parts
Show All
Compactor ram gets stuck
Fixed by
these parts
these parts
Show All
Drawer is hard to open and or close
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Won’t start
Fixed by
these parts
these parts
Show All
Shaking and Moving
Fixed by
these parts
these parts
Show All
Won’t stay on
Fixed by
these parts
these parts
Show All
Watch our pros, then fix it yourself.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More