6430-20 (C53A) Milwaukee Circular Saw - Overview

This is a genuine Milwaukee Taptite-« Pan Head Torx Screw for use with a variety of equipment. Use only appropriate tools of correct size to tighten and loosen the screw while following the basic common safety precautions. Size 10-24 X 1/2.

This is a Genuine OEM approved replacement part designed for use with Milwaukee Circular Saws. It is used to secure the Balde. This part is made out of Metal and it is Sold Individually. Requires a Hex Key or a Wrench to tighten/loosen this Screw.

Included in part number 14-13-0465

This is a genuine OEM sourced part used on a variety of power tools. The wave spring washer is often fitted between a flat washer and an adjustment nut. This item is helpful with securing parts with irregular tolerance or surfaces. The wave spring washer is sold individually. You will need a wrench and a pair of pliers for the installation.

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one needle bearing, and please be aware any associated parts are sold separately. Please refer to your models parts diagram for any additional parts.

This is a Genuine OEM replacement Protector Grommet which is used on Milwaukee Power Tools. This part is made out of Rubber and is Sold Individually. It is important to have a cord protector on your tool to improve friction, seal cable and protect it from a potential damage. Replacing this item would differ based on your tool. • Firs...Read moret you would need to gain access to internal connections of Power Cord by removing housing of your tool • Once you have disconnected Power Cord you would need to loop it through the Protector • Re-Connect Power Cord to your tool • Secure Cord Protector in the Housing opening and assemble your tool

This is available as an individual replacement part. The o-ring hub is made of rubber and goes between the hub and gear. A screwdriver, a set of pliers, and a wrench set may be needed during the replacement of this part. It may become broken and will need to be replaced. This item is an original part from Milwaukee for use in saws.

This is an authentic OEM component from the Milwaukee manufacturer. The lower guard sleeve is compatible in many circular saw models, and is sold individually. This item helps to secure the lower guard machined assembly. For the repair, you will need a hex key. It is recommended to refer to the manual for further safety and repair instructions.