6380-55 Milwaukee - Overview

Genuine Milwaukee replacement part. Includes 1 Carbon Brush with wire lead, brush spring and bracket attached. Two brushes are needed for the tools shown below. • Worn brushes are often the cause behind a a poorly running motor. • Replacing brushes can fix an intermittently operating motor. • New brushes can restore a motor's ele...Read morectric braking. Carbon motor brushes are one of the most commonly replaced power tool parts. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes be sure to also inspect your armature for burns, cracks, or other damage which are indication of a larger motor problem.

This is a genuine Milwaukee Taptite-« Pan Head Torx Screw for use with a variety of equipment. Use only appropriate tools of correct size to tighten and loosen the screw while following the basic common safety precautions. Size 10-24 X 1/2.

Included in part number 14-13-0465

This is a manufacturer sourced replacement part used on a Milwaukee power tools. This part holds carbon brushes around the armature to provide stable and safe contact. Please note brushes are sold separately. This part is made out of plastic and metal. It is sold individually. To replace this assembly you would need a screwdriver and pli...Read moreers. • First remove screws holding the cover together • Separate two (2) halves of the housing to gain access to armature and brush holder • Remove the old brush holder • Install the new brush holder, brushes and the armature • Reassemble and test your tool

This Milwaukee ball bearing is an OEM replacement part. It fits in assorted handheld power tools including various saws, routers, hammers, and shears. Bearings are used to hold moving parts while they rotate/spin. This lowers friction while stabilizing movement direction and angle. Ball bearings are a commonly replaced item because of their high wear role. Sold individually.

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one needle bearing, and please be aware any associated parts are sold separately. Please refer to your models parts diagram for any additional parts.

This is a genuine OEM sourced part used on a variety of power tools. The wave spring washer is often fitted between a flat washer and an adjustment nut. This item is helpful with securing parts with irregular tolerance or surfaces. The wave spring washer is sold individually. You will need a wrench and a pair of pliers for the installation.

This is a genuine OEM sourced from the Milwaukee manufacturer. The hub assembly is constructed of plastic and metal parts, and is compatible with many circular saw devices. This item is fastened onto the mach. lower guard, securing the spindle. This part is sold individually. A screwdriver and a wrench set are helpful in making this repair.