629A105 Kenmore Range - Overview

This is a surface burner knob. This knob is a little under 2 inches in diameter. It is a black part with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. This knob is made entirely of plastic. Its function is to allow the user to control the heat coming from the surface burner on the...Read more range. This model will only accept a D-shaped shaft. To make this repair, grab the knob with a tight grip and pull it straight off the shaft. When you receive your new part, you can snap it back into place.

This down-draft fan switch kit comes with the switch itself and two metallic push nuts. At 125 volts,this switch will allow for 6 amps, and at 250 volts, this switch will allow for 250 volts. This switch runs at 1/4 horsepower.

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

This spark ignition valve switch is an inch and a half long. It is a white switch with a black cam. Sold individually.

This screw is well under an inch long, and is made of metal.

This screw is sold individually. Size: 8-32 x 1/4 inch.

This is a switch that operates a solenoid that closes a circuit to operate the starter

Sold individually.

This part fits inside your range's terminal block to act as an insulator for the contact spade.

Sold individually.

This pressure regulator is three inches long. It is made of metal, but has a blue plastic plug on each end. This regulator sits below a gas range's control panel.