6160 - Overview

Genuine Milwaukee replacement part, this item is sold individually. This Flange nut is threaded on the spindle of the Milwaukee Grinders shown below. You first place the inner flange on the spindle , part number 43-34-0036. Then you place the grinding wheel of choice on the spindle. The Flange Nut is then threaded on the spindle preferably by using a spanner wrench which fits into the holes of the Flange Nut.

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with angle grinders. The metal spring fits into the gearcase and is used to provide compression for the spindle lock button. This item allows the button to be pressed and keeps it in the upright position when not pressed. The compression spring is available as an individual replacement part.

This item has been sourced from the original manufacturer to be used with angle grinders from Milwaukee. The durable plastic tube fits into the grinder's gearbox assembly. The spindle lock tube is used to secure the spring and the spindle lock shaft. The tube is sold as an individual replacement part.

This is an authentic Weber replacement part manufactured for use with outdoor grills. The molded handle attaches to the aluminum damper that is used to vent the grill while in use. This damper handle is sold an individual replacement part, please note the damper is available separately.

This is a genuine OEM approved replacement part used on Milwaukee angle grinders. This wrench allows you to secure or remove a grinding/cutting disk or wheel. Angular profile of this item makes tightening/loosening the flange nut easy. This spanner wrench is made from metal and it is sold individually.

It is an authentic hardware kit that is supplied directly from the original equipment manufacturer for use with Weber grills. This is an identical replacement for missing or faulty hardware that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this...Read more kit. This high-quality kit includes a durable metal pin and the cotter spring to secure the lid.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

It is a high-quality OEM part that is specially made for Porter Cable, Black and Decker and DeWALT power tools. The receptacle is designed to safely secure and connect a wire. It is an identical replacement for a faulty or a missing part that was installed on a new unit. To ensure the correct application, refer to the appropriate diagrams...Read more of your model. Note, this high-quality receptacle is made of durable metal and is sold individually. You will need a screwdriver to take the housing apart when replacing this component.

Genuine Milwaukee replacement part, this item is sold individually. The 43-34-0036 Disk Flange is installed first on the spindle of the grinders listed below. You can then place the grinding wheel or cutoff wheel next. Then the threaded flange nut is tightened on to the spindle to hold the grinding wheel on the spindle.