6148 (SER 856B) Milwaukee Angle Grinder - Overview

This cord protector is a genuine Milwaukee replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This genuine OEM sourced replacement part that is specially made for Milwaukee sanders and grinders. It is secured over the grinding disc to help direct dust and trimmings away from the user. Never operate the tool without the hood guard on. This part is made of durable plastic and it is sold individually, please note the hardware to secure it is sold separately.

This cord is a genuine Milwaukee replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation and a cord protector for a long service life.

Included in part number 14-30-0302

This part is made of metal and is sold individually. The ball bearing fits between the commutator insulator and the baffle. It may require a screwdriver during installation. It might become worn down over time and will need to be replaced. This is an original Milwaukee part for use in grinders and sanders.

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one needle bearing, and please be aware any associated parts are sold separately. Please refer to your models parts diagram for any additional parts.

This is an Original replacement part used on certain Milwaukee Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Flange is to hold the Grinding Wheel to the Spindle Shaft. Flange designed to accommodate 7/8 In. hub depressed center wheel.

This is a Genuine OEM replacement Flange Nut used on Milwaukee Grinders. This part secures the Grinding Disk to the unit. A Spanner Wrench (Sold Separately) is used to tighten and loosen this part. It is made out of Metal and it is Sold Individually.

This is a lock lever for various models of sanders and grinders. This lever is a safety feature designed to stop and prevent the sander disc from spinning when not in use. Not only is this lever a safety feature, it also allows users to change discs without worrying about the disc spinning unintentionally. If your grinder or sander is mis...Read moresing its lock lever, it is imperative that you replace it immediately to avoid personal injury. Replacing this lever requires no tools and can be done by simply pulling the old lever out and installing the new one in its place.

It is a genuine OEM sourced item that is designed for use with Milwaukee power tools. This special bearing allows spindle shaft to rotate freely with minimal friction, over time the rollers of the bearing may begin to wear out and fail eventually requiring replacement. It is a high-quality component which is made of durable steel and it is sold individually.