6147 (Type 100) Black and Decker Sander Polisher - Overview

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This is an authentic Craftsman replacement part that has been sourced from the original manufacturer to be used with angle grinders. The metal disc nut is used to secure the grinding discs to the spindle assembly. This item is available as an individual replacement part.

Genuine Black and Decker replacement part, this item is sold individually. This Terminal is attached to the cord on all of the tools listed below. It is then attach to the electrical connection of the tool.

This is an authentic replacement part manufactured for use with DeWalt, and Black and Decker power tools. Carbon brushes are considered a wear item because they are in constant contact with the spinning armature. Worn brushes can cause a lower level or performance, or cause the power tool to stop working altogether. Most power tools with ...Read morea good amount of use will require the brushes to be replaced at some point. These brushes will come in a pair, and the pair is sold individually.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

This is an Original Manufacturer Sourced replacement Side Handle used on certain Angle Grinders and Sanders/Polishers. This part consists of a Metal Shaft and a Plastic Body. Some Power Tools are equipped with a side handle, which helps you to better control the tool while it is in operation, especially when performing heavy grinding or c...Read moreutting. To replace simply screw in the new handle into the slot in the body of the tool.

This is an authentic replacement part, sourced from the original manufacturer for use with power tools. The o-ring is used with several different types of equipment and the application of the o-ring can vary based on the model of the machine. This item is available as an individual replacement part.