6140-2 (762C) Milwaukee Angle Grinder - Overview

Inner diameter 3/8" Outer Diameter 1"

This is a Genuine OEM replacement Flange Nut used on Milwaukee Grinders. This part secures the Grinding Disk to the unit. A Spanner Wrench (Sold Separately) is used to tighten and loosen this part. It is made out of Metal and it is Sold Individually.

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one needle bearing, and please be aware any associated parts are sold separately. Please refer to your models parts diagram for any additional parts.

A genuine item that is supplied directly from the original equipment manufacturer for use with Milwaukee power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. Keep in mind this high-quality component is made of durable metal and is sold individually. Please refer to the appropriate diagrams of your model for the correct location and application of this part.

This is an OEM part sourced directly from the manufacturer. The rubber bumper protects surfaces from scratching and normal wear and tear. Grinders, sanders and jigsaws are common tools that require this part. This part is sold separately. No tools are required to install this part, simply push into place.

This is an authentic and original replacement part. It fits a variety of Milwaukee handheld power tools. This cord protector prevents strain/damage to the cord where it connects to the tool. One (1) rubber cord protector is included in this purchase. Please note that a replacement cord is sold separately. Depending on your power tool mode...Read morel, a screwdriver should be the only tool needed to complete this repair. • Ensure tool is disconnected from power source • Remove the tool casing • Disconnect cord/wires from tool • Pull cord through the cord protector • Reconnect wires • Reassemble and test out tool

Includes part numbers 02-50-2423, 31-12-0205, 40-50-8650, 34-40-4300 and 44-60-0845

This replacement side handle is a genuine Milwaukee part, not an aftermarket imitation. It is sourced directly from original equipment manufacturer for use with sanders and grinders. This side handle helps you to better control the tool while it is in operation. It consists of a plastic handle and a metal threaded shaft. One item is included per order. Replacing this item does not require any tools.

This is an OEM authorized replacement part designed for use with Milwaukee power tools. This part is used to keep the brush tight against the armature. Over time when the brushes wear down and heat is created, the spring may lose its tension and it will have to be replaced. This item is made out of metal and it is sold individually.