This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.
Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.
This Affresh Washing Machine Cleaner deep cleans to help remove the odor-causing residues and grime that daily loads leave behind. The time-release tablets are EPA Safer Choice certified, septic-safe and designed to clean inside all machines, including HE (High Efficiency). Use monthly or every 30 cycles for a consistently clean machine.
This leveling leg, which includes a lock nut and a pad, is used to keep washing machines still and balanced. If your washer shakes and moves excessively, then this could be an easy and quick solution to your washers problem. To install, the damaged pulley must be removed to install new pulley. The suggested tools are pliers, a socket set,...Read more and/or screwdrivers. For safety precautions, make sure to unplug washer from power source or shut off the house circuit breaker. Remember to wear gloves prior to starting this installation project. Refer to the instructional diagram provided by the manufacturer for further guidance. Customers suggested the detailed diagram as helpful.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Intermittent problem with lid switch, no high speed spin/pump out
48 of 63 peoplefound this instruction helpful.
Linda from La Porte, IN
Easy
15 - 30 mins
Nutdriver, Screw drivers
Disconnect power, unsnap and raise machine top cover w/lid, remove old switch - two screws under lid, taking care to not drop loose actuator lever into machine. Remove control panel back and disconnect switch wire connector. Intall new switch, taking care to not drop loose actuator lever into machine, connect switch wires inside control
... Read more panel. Replace panel cover and lower machine top cover w/lid and snap into place, reconnect power, verify operation...
Read less
Was this helpful?
Thank you for voting!
Lid switch had deteriated over time and no longer made contact
10 of 12 peoplefound this instruction helpful.
James from Rochester, NY
Really Easy
Less than 15 mins
Screw drivers
removed the screw holding the actuator, ordered the new part and replaced it when it arrived. Shipping was really fast and I even received it one day early.
Was this helpful?
Thank you for voting!
Washer Spin Cycle Stopped
7 of 9 peoplefound this instruction helpful.
Diana from La Mirada, CA
Easy
Less than 15 mins
Screw drivers
Removed the screw from the side of the lid of the washer. Took off the old Lid Switch Actuator and screwed in the new one. Took a little elbow grease because the old screw was tight but no longer than 15 minutes tops.