600RDM2JNA600RDMB (2002-03) Jonsered Lawn Mower - Overview

The Dust Shield is a 6-3/4 inch, black plastic part, used to prevent dust or debris fouling the wheel or axle. It attaches inside of the wheel around the axle. Installation is rated as "Easy" and will require a wrench. If broken, damaged, or worn due to fatigue, you will see visable damage and you may have debris getting caught in the axl...Read moree. If broken, replace it. Refer to your make, model and diagram to make sure you're choosing the right part. This part comes individually sold.

Made of high-quality metal, this hex flange locknut is designed for use with various lawn mowers and ride-on mower/tractor models and is sold individually. This locknut attaches to the end of the carriage bolt and is an important component to the axle assembly. This locknut has a 3/8-inch inner-diameter and is 16 threads-per-inch. To repl...Read moreace this locknut, you will need a wrench, and if there are multiple locknuts on your equipment, they may all need to be replaced.

The E-Ring 7/16 is a 7/16-inch silver, metal part which can be attached to various locations on a variety of equipment to snap into grooves and secure parts into place. This part will require pliers to install. If broken, damaged or worn, there may be a problem with the part it is securing and the part should be replaced. Refer to your make, model and diagrams to check if this is the right part.

It is an authentic OEM sourced replacement part that is specially designed for use with lawn mowers. This is a standard hardware which has multiple applications depending on the model of your unit, please refer to appropriate diagrams for correct application. This screw is made high-quality metal and it is sold individually.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with walk-behind lawnmowers. The special wheel is a complete part assembly that has a geared hub that is used as the drive wheel. This wheel is available as an individual replacement part, please note two wheels are required.

This washer is an OEM direct from Husqvarna. Compatible with many lawn mowers, this metal item helps to secure the wheel to the adjuster assembly. An adjustable wrench is helpful for the repair, and the washer is sold individually.

The front retainer shaft fits between the front shaft assembly and the wave washer. This is an OEM part sourced directly from the manufacturer and used in lawn mowers made by Husqvarna, Poulan, and Jonsered. This part is made of plastic and is sold individually. A screwdriver and a socket set might be necessary during the installation of this part. It may become broken and will need to be replaced.

This is an authentic Husqvarna replacement part that has been sourced from the original manufacturer to be used with walk-behind lawnmowers. The ball bearing is used to limit friction between the rotating trans-axle and the fixed rear wheel adjuster kit. The sealed bearing is available as an individual replacement part.

This is a genuine Husqvarna replacement part sourced from the manufacturer. The 5/16-18 Unc shoulder bolt is constructed of high-quality metal, and is compatible with many lawn and garden engines. Please refer to equipment manual and diagram for the specific use of this item. A wrench and screwdriver are most often needed to make the proper replacement.