5KSM175PSFCU6 Whirlpool Mixer - Overview

This part is a retaining ring, sometimes called a retaining clip, that holds the drum support roller onto the shaft of a dryer. It is made entirely of metal and measures less than an inch in diameter. The retaining ring is a genuine OEM part sourced directly from the manufacturer. The ring may vary in appearance due to manufacturer substi...Read moretution, but the function is the same. You may need to replace this part if the dryer is noisy during tumbling, will not tumble, or takes too long to dry. Be sure to check drum support roller kit and shaft before ordering parts.

This Flat Beater Part Number WPW10672617 is for Stand Mixers. Attaches to the beater shaft and is for normal to heavy mixtures such as cake batters or cookie dough. This has a powder coated finish.

This wire whip is for stand mixers. Wire whip attaches to the beater shaft and incorporates air into cream, eggs and frostings. Follow the instructions in the owner's manual for using and installing this part.

This part is used with the stand mixers attachments, as well as to hold the end cap to the front of the mixer.

Used in Mixers.

The speed control lever on your stand mixer allows you to adjust the speed that the mixer is running at. The lever is approximately 3.5 inches long, with a black plastic handle at the top. The speed control lever connects to the interior of your stand mixer, so you will have to take it apart to access the bar that the lever is attached to...Read more. Once you’ve opened the mixer, you can unscrew the old lever, taking care not to misplace the screw or washer that holds it in place. Replace the old lever with the new one, and then put the mixer back together.

Use with stand mixers. Screws are not included. Cap only.

This is a powder coated dough hook used on stand mixers.

This speed governor, or clutch, can typically be found in your tilt-head or bowl-lift mixers beside the control plate. It is one of the three parts that work together to regulate and control the mixing speed. If you notice speed fluctuations or unresponsiveness to adjustments, the speed governor may be malfunctioning. To replace it, consu...Read morelt your user manual for instructions. Start by disconnecting the mixer from its power source and removing the beater and bowl. Take off the rear cover and unscrew the mounting screws from the trim to remove it. Disconnect the wires on the control plate and pry the end seal from the appliance. Remove the fasteners on the control plate to access the governor, which can be wiggled off the shaft using pliers. Please be aware that this OEM part is sold individually.

Used on Stand Mixers.

Used with Stand Mixers.