5901562 Simplicity Lawn Mower - Overview

This is a genuine OEM sourced replacement exhaust gasket. It is specially made for use with Briggs and Stratton engines commonly used on Toro lawn and garden equipment. Its purpose is to provide an air-tight seal between the carburetor and the exhaust tube. Over time this gasket will deteriorate requiring replacement. Please note, this co...Read moremposite gasket is sold individually. To replace this part you will need a wrench.

This replacement switch is a genuine OEM part, not an aftermarket equivalent. It is supplied directly from original equipment manufacturer for Murray riding lawn mowers and tractors. This switch is secured under the seat to prevent the engine from running without a driver in a seat. Mechanical switches over time tend to wear out requiring replacement. Please note, this plastic switch is sold individually.

Switch push button no/nc snap-in

BOLT, 5/16-18 x 3/4" Short Neck Carriage, GR 5

It is a genuine manufacturer-sourced component which is specially made for use with Murray, Snapper and Simplicity riding lawn mowers and garden tractors. It is the part of the equipment that allows a user to engage and disengage the blades. Unfortunately, over time components will wear out and may begin to fail eventually requiring a rep...Read morelacement. Keep in mind this high-quality plastic body switch is sold individually. Please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of this part.

This is a genuine item that is supplied by the original equipment manufacturer for use with Murray, Snapper and Simplicity lawn and garden equipment. It is an identical replacement for a missing or faulty bearing brongze flang that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the cor...Read morerect location and application of this hardware. This high-quality component is made of durable metal and is sold individually, keep in mind the hardware to secure it is sold separately.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This is a genuine part which is supplied directly from the original equipment manufacturer and is used with Craftsman lawn tractors. The solenoid support engages and routes the battery electrical supply to the engine starter when the ignition switch is turned to the start position. This part is made of hard plastic and metal, it is also s...Read moreold individually. The tools you will need for this repair are a screwdriver and socket wrench.

This Hair Pin is a metal, silver, individually sold pin measuring .0915 x 1-7/8. It is used to secure parts in place, or to prevent fasteners from backing out, and can be used in various locations on a variety of equipment. Installation is rated as "Easy" by users and doesn't require any special tools. If broken or damaged, it should be r...Read moreeplaced. Refer to your make, model and diagrams to ensure this is the correct part.

This hex center lock nut is sourced from the original manufacturer for use in lawn and garden power equipment. It is a hexagon-shaped fastener for bolts/studs that is responsible for the keeping the bolt/studs secure during use. The nut is made of metal and has a diameter of 5/16 of an inch and a thread pitch of 18 internal threads per in...Read morech. Over time the threads in the nut can wear down and the nut itself may crack or break. It is important to replace it as soon as necessary to avoid damaging your equipment. Use a socket or wrench to remove the old nut and thread the new one on. Make sure to order the correct number of nuts for your equipment as each nut is sold individually.

This is a genuine Craftsman replacement part that is sourced from the original manufacturer to be used with snowthrowers. The metal hex nut is commonly used to fasten the bolt that secures the height skid to the auger housing. This item is available as an individual replacement part, please note four nuts may be required.

Wheel gauge