This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ice tray can be filled up with water and is the mold that shapes the ice cubes. If your current ice tray is cracked, warped, or if mineral d...Read moreeposits have settled inside it, it may cause the ice cubes to stick. This part is sold individually and is an authentic OEM part.
This evaporator fan motor is a replacement drive component designed to circulate air across cooling surfaces. It supports even temperature distribution and is commonly replaced when airflow decreases or the motor fails to run smoothly.
The fan motor helps circulate air through the refrigerator to maintain steady cooling, reduce warm spots, and keep temperatures consistent. When it wears out, you may notice weak airflow, unusual noise, or poor cooling performance. A direct replacement designed for select models, this low-voltage motor restores proper air movement through the compartments and supports efficient, reliable refrigerator operation.
This door gasket assembly creates a tight seal between the door and cabinet, helping maintain internal temperatures and improve efficiency. It is commonly replaced when the gasket becomes torn, brittle, or no longer seals properly.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The ice tray had warped and dumped water, which then froze down through the ice bucket and below.
8 of 8 peoplefound this instruction helpful.
George from ATLANTA, GA
Easy
Less than 15 mins
Screw drivers
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting. Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards. The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and
... Read morethen insert the new tray. Proceed in reverse. Takes only a few minutes.
/Users/grf/Desktop/fridge ice tray.pdf
Read less
Was this helpful?
Thank you for voting!
Replace Gasket on refrigerator door
6 of 10 peoplefound this instruction helpful.
Curtis from DEMOPOLIS, AL
A Bit Difficult
30 - 60 mins
Screw drivers
The replacement gasket does not have as strong a magnet as the original one. I removed the old one carefully so as not to cause more damage in case I have to put it back. Using Tongue suppressor I pushed new gasket into place and put a thin coating of protelem jelly on the gasket. I just have to make sure the door is closed each time to
... Read morebe sure of good seal.
Read less
Was this helpful?
Thank you for voting!
gaskets worn out again
1 of 2 peoplefound this instruction helpful.
Keith from Phoenix, AZ
Really Easy
Less than 15 mins
replaced gaskets for the second time in four years