The lower rack provides easy loading with flexibility for small and large items, and helps hold the dishes in place during the wash and dry cycle. The rack measures approximately 22-inch x 21-inch. The rack is light gray in color with wheels included, lower fold down, and a flexrow retainer. This is a genuine OEM part.
A rusty or bent upper rack can make dishes hard to load and may block the spray. The replacement rack provides storage for smaller dishes and slides along the upper rails. First check the wheels, clips, adjusters, spray parts, and rail stops for wear. These items are not included with the rack. Match the rack to the complete appliance mod...Read moreel and compare its size and mounting points. Remove all dishes, support the rack while sliding it out, and note where each part fits. After installation, make sure the rack moves freely and cannot leave the rails.
This pump and motor assembly is intended for use with some dishwashers. It comes complete with a relay and a spray nozzle. The motor included here performs 3450 revolutions per minute and carries 120 volts. Use this kit with your dishwasher manufactured in the early 1980's.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
bottom rack was starting to rust away and we needed a new one
19 of 27 peoplefound this instruction helpful.
pat from muncy, PA
Really Easy
Less than 15 mins
The dishrack came in one box I opened the box snapped on the rollers and the bumpers and put it in the dishwasher, could not have been easier Thank you partselect
Was this helpful?
Thank you for voting!
rollers and clips on botton dishrack were broken
20 of 38 peoplefound this instruction helpful.
Diane from Waltham, MA
Really Easy
Less than 15 mins
Pliers
I pulled off the old clips and easily replaced them with the new clips and popped on the wheels. I replaced 8 clips and 8 wheels in less than 15mins
Was this helpful?
Thank you for voting!
Coating on the rack has worn exposing the metal underneath
13 of 20 peoplefound this instruction helpful.
Susan from Shelby Township, MI
Really Easy
15 - 30 mins
There were no instructions with the part, but looking at the old rack it was simple to see how the parts should be assembled. Took the center part from the old rack, twisted off, and applied it to the center of the new rack. Snapped on the wheels and was done. Very simple assembly.