56008 - Overview

This cotter pin is an OEM part that is 1.25 inches long, gold in color, and sold individually. Made of metal, it can have a range of applications on a variety of lawn and garden equipment. Generally, you will need to replace this part if it becomes broken due to age and wear, or if you need to remove it for making other repairs. This is...Read more an easy repair that only requires a pair of pliers to carry out. You need to bend one end around the shaft or bolt and bend the other around the back end of the bolt to complete the repair.

This Ball Bearing is an individually sold, silver/black, metal part. It reduces friction in the spindle assembly between the spindle shaft and the spindle housing. If broken due to wear/fatigue, you will hear a grinding, growling, rumbling or screeching sound, and should replace the part. Refer to your make, model and diagrams to ensure this is the right part for you.

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

BOLT, 5/16-18 x 3/4" Short Neck Carriage, GR 5

This metal washer is a genuine OEM part that is commonly used on various lawn equipment and is typically used to secure and seal connected components. This washer is high-quality and is sold individually, so consult with the relevant diagrams for your model to correctly determine where this washer would be for your equipment, and whether you need one, or more.

This Hair Pin is a metal, silver, individually sold pin measuring .0915 x 1-7/8. It is used to secure parts in place, or to prevent fasteners from backing out, and can be used in various locations on a variety of equipment. Installation is rated as "Easy" by users and doesn't require any special tools. If broken or damaged, it should be r...Read moreeplaced. Refer to your make, model and diagrams to ensure this is the correct part.

The pushnut retainer goes next to the ball bearing. This is available as an individual replacement part. This item is an OEM from Snapper, Murray, and Simplicity for use in lawn mowers, lawn tractors, and snowblowers. It might require a wrench to replace this part. It is made of metal and will need to be replaced if it breaks.

This is a genuine Craftsman replacement part that is sourced from the original manufacturer to be used with snowthrowers. The metal hex nut is commonly used to fasten the bolt that secures the height skid to the auger housing. This item is available as an individual replacement part, please note four nuts may be required.

A genuine item which is supplied directly from the original equipment manufacturer for use with Murray and Snapper lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check the appropriate diagrams for the correct location and use of this screw. Keep...Read more in mind this high-quality component is made of durable metal and is sold individually.

V-Belt

The retainer attaches to the idler arm support. This genuine item is supplied by the original equipment manufacturer for use with tractors and rear engine riders made by Snapper, Murray, and Simplicity. It is made out of metal and is sold individually. During the installation process, a wrench set might be needed to replace this part. Over time this part may break and will need to be replaced.