55549 Weber Grill Accessories - Overview

This is an authentic Weber replacement part that has been sourced from the original manufacturer to be used with natural gas grills. The brass coupler is used to connect the fuel hose to the natural gas supply. This quick disconnect is sold as an individual replacement part, tools may not be needed to install this item.

This is a genuine Weber part used with Genesis and Spirit grills. This assembly includes the hose and regulator as well as the manifold. The regulator controls the release of gas from the tank into the fuel line to the manifold. The manifold then directs the fuel to the burners. It includes installation hardware and written instructions.

This is a manufacturer sourced replacement thermometer designed for use with Weber grills. It can be used to measure temperature inside the grill and the temperature of the food. This part is made out metal and it is sold individually. Wingnut is included. Dial reads 150 - 600 degrees.

This is a genuine Weber replacement part that is specially designed for use with gas grills. This bottom tray will catch the grease drippings providing and easy way to keep your grill clean and ready for service. This is a black porcelain enameled steel tray that is sold individually.

This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.

This is a genuine Weber replacement part manufactured for outdoor gas grills. The metal tray rails support the drip pan, and each rail will mount using one screw. This bottom tray rail set will come with two screws, and two rails. The sets are sold individually.

This is an authentic kit made for the lid on Weber grills. This is a 14-part set that includes two posts, two retaining clips, and ten hex nuts. The posts are used to secure the lid to the body of the grill while allowing it to swing freely as a hinge. The ends of the posts have small holes that the retaining clips slide into to keep them in place.

This is an original Weber part manufactured for use with outdoor grills. The control panel plugs with screws fasten the control panel to the side frame. Only two plugs are required to secure the control panel, and this set will include both plugs, and two screws, please note the set is sold individually.

Genuine Manufacturer Approved replacement Burner Tube Set designed for certain Weber Grills. Consists of 1 crossover tube and 3 burner tubes. These tubes are made out of stainless steel. They allow grill temperature to be properly maintained. Easy to install with included hardware and instructional guide.