5520K17 Rolair Compressor - Overview

This is a genuine OEM sourced replacement isolator foot that help to keep you air compressor stable and also help to minimize the vibration. This item is made out of rubber with metal and it is sold individually. Please note the screw used to attach it is sold separately. You would need a wrench to replace this item.

This is an authentic replacement part manufactured for use with Rolair wheeled compressors. The handle grip is used to provide a better grasp on the handle when moving the compressor. This handle grip is sold as an individual replacement part.

This drain valve is an OEM direct from Rolair. Compatible with electric and gas compressors, the metal part is fitted at the base of the tank. This item allows the operator to drain the tank following each extended use. Regularly draining the tank prevents rust and leakage. The drain valve is sold individually. A wrench set may be necessary for the proper removal and installation.

This is an authentic Rolair replacement part that has been sourced from the original manufacturer. The hose clamp is intended to be used with air compressors. This metal clamp is used to secure the air hoses to the coupler on the manifold and the quick disconnect. The hose clamp is sold as an individual replacement part.

This is a genuine OEM approved replacement part designed for use with Rolair compressors. The pressure switch is a mechanism which communicates to your compressor when to stop and when to start building up pressure. There are multiple reasons a pressure switch could be leaking air. To complete this repair you would need: wrench set, nut ...Read moredriver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

This is a genuine Rolair replacement part that is sourced from the original manufacturer to be used with air compressors. The special brass elbow is commonly used to link the nylon tube and the unloader valve, but the application can vary based on the model of compressor. This brass elbow is available as an individual replacement part, see illustrated part list for part location and usage.

This regulator is supplied directly from the original equipment manufacturer. Constructed of durable metal and plastic, this item is made for use with several air compressors. The regulator is fastened to the accessory bracket, allowing the operator to select the amount of air pressure for the tool in use. A wrench or pair of pliers may b...Read moree required for the removal and installation. The regulator is sold individually. Please refer to manual for repair and safety instructions.