53848119 General Electric Washer Parts & Repair Help | PartSelect
Models > 53848119

53848119 General Electric Washer - Overview

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(6)
PartSelect #:PS270803
Manufacturer #:WH1X2026
This V-shaped drive belt is 29 1/2 inches long x 1/2-inch-wide, and fits both front-load and top-load washing machines. When belts are worn or frayed, they are known to make noise....
$8.90
In Stock
(1)
PartSelect #:PS271187
Manufacturer #:WH1X484
$6.57
In Stock
PartSelect #:PS270875
Manufacturer #:WH1X2296
This friction snubber pad is an inch and a half long.
$11.78
In Stock
PartSelect #:PS273876
Manufacturer #:WH8X281
This seal goes to bottom of the transmission to stop oil from leaking at the bottom of the appliance.
$33.95
In Stock
PartSelect #:PS271458
Manufacturer #:WH2X1137
This levelling leg is less than three inches long.
No Longer Available
PartSelect #:PS267704
Manufacturer #:WE2X263D
$9.31
In Stock
PartSelect #:PS270759
Manufacturer #:WH1X1722
This coupling helps connect the pump to the motor.
No Longer Available
PartSelect #:PS270791
Manufacturer #:WH1X1953
$9.05
In Stock
PartSelect #:PS273882
Manufacturer #:WH8X291
No Longer Available
PartSelect #:PS273727
Manufacturer #:WH4X12
$50.53
In Stock
Questions and Answers for 53848119
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

GE washer no spinning during spin cycle

V-Style Drive Belt – Part Number: WH1X2026
  • Customer: Laurence from Bronx, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 159 of 174 people found this instruction helpful
Used the spatula to release the front panel (push flat spatula under top about 2 inches from either side to release the two sprng clips holding the front panel on) to expose the tub and motor assembly. Inspected the belt and it seemed worn and a lot of rubber particles were in base of machine. Ordered the belt from partselect - received it two days later. Lo... read more

washer was not agitating or spinning

V-Style Drive Belt – Part Number: WH1X2026
  • Customer: Rachelle from Kent City, MI
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 58 of 62 people found this instruction helpful
My washer was making noise but not agitating or spinning on any of the cycles that I turned the dial to. Didn't know if it was the transmission or something simple. I did some research and discovered it may be the belt, even though the belt looked new, I changed it anyway by just removing the front of the washer and cutting the belt off and putting the new b... read more

lost all gear oil bottom of transmission

Lower Shaft Seal – Part Number: WH8X281
  • Customer: opal from richmond, KS
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set, Wrench set
  • 26 of 29 people found this instruction helpful
put washer on its side,removed 1cross section,loosened the nut that held on the pulley.
loosened the motor and removed drive belt,removed drive pulley,removed old seal,poured in 90 weight gear oil,installed new seal and done everything else in reverse order.
stood washer upright connected water hoeses,waste water discharge hose,set washer to spinan... read more