5359 - Overview

This is an authentic manufacturer-sourced replacement flat washer which is specially produced for use with Murray lawn and garden equipment. It helps to distribute the pressure evenly between connected pieces, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. This high-quality metal washer is sold individually.

The oil seal goes between the gear case and the flange bearing. This authentic item is supplied directly from the original equipment manufacturer for use with snowblowers made by Murray and Simplicity. The part is sold individually and is made of metal and rubber. A screwdriver might be helpful during the installation of this part. It will need to be replaced if it breaks or loses its seal.

Roller bearing .750idx1.2

This item is sold individually. The choke bracket is made out of metal. A screwdriver and a socket set might be needed during the installation process. This part may become broken and will need to be replaced. It is a genuine item that is supplied by the original equipment manufacturer for use with engines and snowblowers made by Tecumseh, Husqvarna, and Toro.

This replacement item is supplied by the original manufacturer for use with Craftsman lawn and garden equipment. It is an identical replacement for a missing or a faulty locknut that was installed on a new unit. This is a standard hardware that was installed on a new unit, please make sure to refer to the appropriate diagrams of your mode...Read morel for the correct location and application of this component. Keep in mind this high-quality item is made of durable metal and is sold in a pack of eight.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This replacement washer is supplied by the original equipment manufacturer for use with Craftsman equipment. It helps to distribute the pressure evenly and provide a tight seal between the connected pieces. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality pack includes eight durable metal washers.

This carbon brush is an authentic DeWalt replacement part. It is sold individually, 2 are needed to make a set • Worn brushes are frequently the cause of a poorly running motor. • Replacing brushes can fix an intermittently operating motor. • New brushes can restore a motor's electric braking. Carbon motor brushes are one of the mo...Read morest commonly replaced power tool parts. The reason is that carbon brushes are wear items, meaning that through friction and use they will gradually wear away and eventually will need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, also check your armature for burns, cracks, or other damage which are indications of a larger motor problem needing attention.

This is an authentic replacement part manufactured for use with Craftsman outdoor power equipment and power tools. The pins are used with different types of equipment and their application varies depending on the model of equipment. These pins are sold in packs of two pins and the two packs are sold individually.