5316 - Overview

This is a genuine brush set designed for use with Milwaukee rotary hammers. This assembly includes two (2) carbon brushes with lead wires attached. Please note brush holders are sold separately. Due to prolonged contact with an armature brushes will gradually wear down and will require replacement. It is advised to replace both brushes a...Read moret the same type. To complete this repair you would need a screwdriver. • Make sure the unit is unplugged • Remove screws from the housing to gain access to the armature and brushes • Remove old brushes and secure the new ones in brush holders • Re-assemble and test the tool

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with rotary hammers. The special o-ring is used to seal the space between the striker and the inside of the barrel. The o-ring is sold as an individual replacement part.

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with rotary hammers. The special side handle connects to the gearcase assembly and is used to provide the user with a support to better control the rotary hammer. The side handle is available as an individual replacement part, please see model diagram for associative parts.

Included in part number 14-13-0465

This is an OEM part sourced directly from the manufacturer. The wire harness is commonly found in Hunter ceiling fans. This is a set of two complete components, which are used to hold the wires that sent electrical signals through the machine.

This is a genuine OEM sourced replacement screw which is made for use with Husqvarna saws. It is a special hardware which has multiple applications depending on the model of your unit, please make sure to refer to the appropriate diagrams for the correct location and application of this part. Keep in mind this high-quality item is made of durable metal and is sold individually.

This is an original Milwaukee replacement part. The square nut is found in Milwaukee rotary hammers. This is a metal part, used to hold the side handle and clamping band into the clamp holder. No tools are required when replacing this part. Simply unscrew the side handle and remove the clamping band so you can remove the old part. The new part can then be slotted into place. This item is sold individually.