5313 - Overview

This wire harness is a genuine OEM part designed for ceiling fans. The capacitor for this wire harness is red 300VAC, brown 250VAC, and purple 250VAC. The wire harness is responsible for providing power between the internal components of the fan, such as the lights and motor. The harness also organizes and insulates wires for safety and e...Read moreasy access. If your ceiling fan lights are not working, the controls are not responding, or the fan will not start, you will need to replace the wiring harness as it may be damaged or overheating. To begin the repair, remove the motor housing, blades, and fan canopy. Locate the wire harness inside the motor housing and take note of how the wires are connected to each terminal. Disconnect the faulty harness and remove it from the motor housing. Insert the new harness in the housing and connect the wires to the appropriate terminals using your notes from earlier. Reassemble the fan and switch it on to check for functionality.

It is a genuine replacement o-ring which is supplied by the original equipment manufacturer for use with Dynabrade power tools. This item is utilized to provide an air-tight seal between connected parts, please make sure to check appropriate diagram of your model for the correct use and location of this component. Over time o-rings tend t...Read moreo deteriorate and crack eventually requiring replacement to maintain peak performance. It is a high-quality part that is made of durable rubber material and it is sold individually.

Included in part number 14-13-0465

This cord protector is a genuine Milwaukee replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This genuine manufacturer-sourced component is made for use with Milwaukee power tools. It is an identical replacement for a missing or a faulty 5mm ball that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This is a genuine OEM replacement part. This steel bearing is used in a variety of Milwaukee handheld power tools including rotary hammers and Sawzalls. Ball bearings serve to separate and buffer moving parts. They also assist with directional stability. They are therefore a high-wear part that is replaced regularly. This item is sold individually. Retaining rings and spacers sold separately.