52863 Dynabrade Grinder - Overview

This genuine Dynabrade replacement part is used in various power sander models. An O-ring is made to act as a flexible part connecting solid pieces, sealing and retaining pressure inside. Assorted styles of O-ring are often used in more than one spot in a machine, so ensure that the right one is being used for the right place. This item is sold individually.

This authentic replacement part is designed for use with Dynabrade power tools. Ball bearings are used to reduce friction between rotating parts. It is one of the bearings for the rotor. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time bearings may be...Read moregin to wear out compromising tools functionality and eventually requiring a replacement. This part is made from durable metal and it is sold individually.

This authentic component is supplied by the original manufacturer for use with Dynabrade power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Bearings experience c...Read moreonstant wear from pressure, heat, vibration and friction, eventually requiring a replacement to ensure top performance. Keep in mind this high-quality part is made of durable metal and is sold individually. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware.

This is a genuine manufacturer-approved component which is designed for Dynabrade sanders and grinders. It is an identical replacement for a missing or a damaged pin that was installed on a new unit. This is one of the pins for the rear end plate. Refer to the owner's manual and the parts diagram for your model to ensure the correct repla...Read morecement procedure. Note, this high-quality pin is made of a durable metal and is sold as an individual item. A screwdriver and pliers will be needed to perform this repair.

This is an original replacement part sourced directly from the manufacturer. The collet body is commonly found in Dynabrade die grinders. This part is made of metal, and is used to hold the collet insert. You will require a wrench when replacing this product. This item is sold as an individual replacement part.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine Dynabrade replacement part manufactured for use with orbital sanders, and grinders. This special valve sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see model diagram for additional parts that are available separately.