466224611 Char-Broil Grill - Overview

This stainless steel cleaning tool is an OEM part sourced directly from Char-Broil. This tool was designed to scrape off cooked on food or grease from the grates of the grills listed below. Using this tool to maintain the cleanliness of the grill will extend the life of the grates. One item is included per order.

This is a genuine OEM replacement part for a Char-Broil Outdoor Stove. The grease tray is designed to catch grease drippings from food as it cooks. Before replacing this part make sure the stove is completely cooled down to avoid any possible injury. This part is made of metal with a grey powder coat finish. It is a separately sold replacement part.

This is a genuine manufacturer sourced replacement parts designed for use with Char-Broil gas grills. The purpose of a heat tent is to direct grease and drippings away from the burner tubes. This will greatly cut down on flare ups. Tents will normally begin to rust due to the combination of heat and moisture. This item is made out of steel with porcelain coating and it is sold individually.

This is a manufacturer approved replacement part designed for use with Char-Broil gas grills. This item is made out of metal and it is sold individually. The carryover tube provides support for the burners, and carries the flame from one burner to the next. They also help to secure the burners in place. Over time, your carryover tubes may...Read more rust or warp. This would be the time to replace them. This assembly includes two (2) cotter pins.

This is a genuine Char-Broil replacement part, sourced from the original manufacturer for use with outdoor grills. The bumper is silicone rubber, and used on the main lid. This bumper protects the lid and burner box from damage when closing the lid. The bumper is sold individually.

This item is a genuine Char-Broil replacement part that is intended to be used with outdoor gas grills. The metal rail attaches to the bottom side of the firebox and is used to mount the grease tray to catch food drippings. The left rail is priced as a single replacement part.

An authentic manufacturer-sourced item that is specially designed for use with Char-Broil grills. This is one of the rails used to support the grease tray. It is a high-quality component which is made of durable metal and it is sold individually, please note the hardware to secure it is sold separately.

It is an authentic OEM part which is specially designed for Char-Broil grills. The electrode provides a spark that arcs to the main burner to ignite the gas. If the burner won't light, first clean the electrode and check that it's aligned. If the problem persists, replace the igniter electrode. This item will provide an identical replacem...Read moreent for the original part that was installed on a new unit. Refer to the diagrams of your model for the correct installation of this component. Note, one durable ceramic electrode with an attached wire is included. Replacing it is a simple task that only requires a screwdriver.

This locking caster is sourced from the original equipment manufacturer for use with outdoor grills. It consists of a wheel, with a diameter of 3 inches, and a metal bracket that allows for easy transportation and positioning. It also includes a locking mechanism that prevents unintentional movement of the grill. Over time, the caster may...Read more break, corrode, or fall out of alignment, thereby causing instability, failure of the locking system, and potential accidents. The caster will also need to be replaced if it is jammed or stripped. To replace a defective caster, prop the grill up and use a wrench or screwdriver to turn and remove the caster mounting bolt. Remove any dirt and debris in the area and align the new caster with the mounting hole. Turn the caster until it is firmly locked in place to complete the repair.

The sideburner burner goes next to the sideburner. It is an authentic OEM sourced item which is specially produced for use with Char-Broil grills. This item is available as an individual replacement part. A screwdriver may be helpful when replacing this item. This part may become broken and will need to be replaced.