465878 Char-Broil Grill - Overview

This is an individual plastic wheel compatible with various models of outdoor grills. This wheel attaches to an axle rod at the bottom of the grill assembly, allowing you to move it around. If you find your grill difficult to move and notice that the wheel(s) do not rotate or move smoothly due to damage or warping, you will need to replac...Read moree this wheel. Consider ordering multiple wheels if you find that more than one is not moving properly. This wheel measures approximately 6 inches in diameter and has a 1 1/16-inch outer diameter and 3/8-inch inner diameter bearing. To replace this wheel, you only need to remove the pin that secures it to the axle rod. Then, you can slide off the old wheel and install and secure the new wheel in place.

This is an authentic Char-Broil replacement part manufactured for use with outdoor gas grills. The wire has rounded push on connectors at each end and is used to carry an electric charge from the ignitor to the electrode to light the main burners. This wire is sold as an individual replacement part. • 11" in length.

This cooking grate is a genuine Weber replacement part that is specially manufactured for use with gas grills. It used to support the food over the burners providing for the best grilling experience. It is advised to clean it after each use to prevent rusting which normally is caused by the heat and moisture from the left over food. This cooking grate made from durable metal and it is sold individually.

This is a genuine OEM supplied component which is specially made for use with Char-Broil grills. It is a standard hardware which may have multiple applications, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this pal nut. This part provides an identical replacement for a mis...Read moresing or a faulty component that was included with a new unit. Keep in mind this high-quality nut is made of durable metal and is sold individually.

This is an authentic part that is supplied directly from the original equipment manufacturer for Char-Broil gas grills. The control knob controls the burners on and off functions as well as the heat controls. This part is made of plastic and is sold individually, though two are required for the unit. There are no tools required for this part, simply slide onto the shaft and twist to secure into place.