464720907 Char-Broil Grill - Overview

This replacement grease cup is specially designed for use with Char-Broil grills. It is an authentic item that is sourced directly from original equipment manufacturer. The purpose of this tray is to collect the grease and other food particles from the food you are cooking. After each use it is recommended to clean this part with soap and...Read more water to avoid rusting. This item is made out of metal and it is sold individually. Please note, the grease cup clip/holder is sold separately.

This is an individual plastic wheel compatible with various models of outdoor grills. This wheel attaches to an axle rod at the bottom of the grill assembly, allowing you to move it around. If you find your grill difficult to move and notice that the wheel(s) do not rotate or move smoothly due to damage or warping, you will need to replac...Read moree this wheel. Consider ordering multiple wheels if you find that more than one is not moving properly. This wheel measures approximately 6 inches in diameter and has a 1 1/16-inch outer diameter and 3/8-inch inner diameter bearing. To replace this wheel, you only need to remove the pin that secures it to the axle rod. Then, you can slide off the old wheel and install and secure the new wheel in place.

This replacement heat tent is designed for use with gas grills. It is supplied directly from original equipment manufacturer. The heat tent is used to direct the grease and drippings away from the burner tubes. This will help to greatly reduce flare ups and add that "cooked on a grill" flavor to your food. Tents would normally rust in the...Read more combination of heat and moisture. If a tent is damaged or lost it should be replaced. This item is made out of steel with porcelain coating and it is sold individually.

This is an authentic Char-Broil replacement part. The cooking grate is designed by the manufacturer for use in grills. This part is made of metal, and is used to hold food above the burners for cooking. No tools are required when replacing this item. Simply remove the old part and insert the new one in its place. This item is sold individually.

This is a genuine manufacturer-approved replacement burner assembly which is specially designed for use with Char-Broil grills. It is the component that the flames would rise from, over time it may wear out or get damaged eventually requiring a replacement. This high-quality part is made of durable stainless steel and is sold individually, keep in mind the heat tent is sold separately.

This is an authentic Char-Broil replacement part that has been sourced from the original manufacturer to be used with outdoor gas grills. The metal hinge connects to the rear of the firebox and is used to link the upper hinge to create a complete hinge that allows the lid to stay connected to the firebox. This item is available as an individual replacement part. A screwdriver is needed to install this item.