464222409 Char-Broil Grill - Overview

This is a genuine Char-Broil replacement part, it is sold individually. This is the part of the Grill that the flame is coming from on your Gas Grill. Depending on your grill you may have 3 or 4 of these. To connect these to your grill, place the flat side of the Burner in the rear side of the firebox in the slots provided. The front of t...Read morehe burner will connect to the Electrode W/ Wire/Collector. They will connect to the Hose Valve Regulator, and then the Control Knobs will be attached, so the flame can be controlled. This part includes one threaded pin and one cotter pins.

This is a genuine OEM replacement part for a Char-Broil Outdoor Stove. The grease tray is designed to catch grease drippings from food as it cooks. Before replacing this part make sure the stove is completely cooled down to avoid any possible injury. This part is made of metal with a grey powder coat finish. It is a separately sold replacement part.

Discover the reliability and convenience of the Char-Broil Electronic Ignition Module designed for gas grills. It plays an essential role in the function of your grill by supplying power to the igniters, allowing for an easy and quick start to your barbecuing. To enhance the longevity of your grill and experience the best performance, thi...Read mores ignition module is a must-have. Not only it ensures efficient operation, but also it enhances the safety and durability of your grill. Remember to wear work gloves for your safety during the installation. Upgrade your grilling today with this essential Char-Broil component.

This thermometer/ temperature gauge is a genuine manufacturer sourced replacement part. It is specially designed for use with Char-Broil grills. It can be used to measure temperature inside the grill. This part is made out metal and it is sold individually. It does include a wingnut that helps to secure it to the unit. Dial reads 150 - 650 degrees. No tools would be needed to replace this item.

This is a genuine Char-Broil replacement part, sourced from the original manufacturer for use with outdoor grills. The bumper is silicone rubber, and used on the main lid. This bumper protects the lid and burner box from damage when closing the lid. The bumper is sold individually.

This is a genuine Char-Broil replacement part, sold individually. Stainless steel carryover tube. Tube channel measures 4-3/4" long. (this measurement does not include the mounting tabs). Comes with 2 cotter pins. Carryover tubes connect the gas grill burners and carry the flame from one burner to the next. Over time, your carryover tubes may rust or warp. This would be the time to replace them.

This locking caster is sourced from the original equipment manufacturer for use with outdoor grills. It consists of a wheel, with a diameter of 3 inches, and a metal bracket that allows for easy transportation and positioning. It also includes a locking mechanism that prevents unintentional movement of the grill. Over time, the caster may...Read more break, corrode, or fall out of alignment, thereby causing instability, failure of the locking system, and potential accidents. The caster will also need to be replaced if it is jammed or stripped. To replace a defective caster, prop the grill up and use a wrench or screwdriver to turn and remove the caster mounting bolt. Remove any dirt and debris in the area and align the new caster with the mounting hole. Turn the caster until it is firmly locked in place to complete the repair.

This is an authentic replacement part manufactured for use with Char-Broil outdoor grills. The rubber bumpers are used with the side burner lid to prevent damage to the self or lid. This rubber bumper is available as an individual replacement part.

This replacement batter cap is an authentic OEM item specially designed for Char-Broil grills. It is use to secure the battery in the electronic ignition module. Please note one durable plastic cap with a metal spring is included per order.