463845804 Char-Broil Grill - Overview

This is a Genuine Manufacturer Approved replacement Burner designed for Char-Broil Grills. This part is made out of Stainless Steel and it is Sold Individually. This is the Part that the flames rise from and allow grill temperature to be properly maintained. This Round burner used in sets of two or three depending on grill model. Ignito...Read morer electrode is included in this Assembly and it comes already mounted on the rear of the burner. No special hardware is required to replace this Burner, simply slide it on the Nozzle of the Valve Assembly.

This replacement temperature gauge is specially designed for use with Char-Broil grills. It is an authentic OEM sourced item, not an aftermarket equivalent. This gauge is used to measure the temperature inside the grill. This part is made from durable metal and it is sold individually. Please note, the wing-nut and the washer to secure it are both included in this assembly. Dial reads 50 - 700 degrees.

Genuine Char-Broil replacement part, this item is sold individually. The burner tent is placed on the 4151014 burner tent support. It sits just under the cooking grate. The purpose of the burner tent is to keep the burner clean an free of debris. It will also help prevent fire flare ups.

This is an authentic manufacturer approved replacement part that is specially made for Char-Broil grills. The carry-over tube provides support for the burners, and carries the flame from one burner tube to the next. Over time due to a combination of heat and moisture tubes may begin to rust or warp eventually requiring replacement. This item includes one stainless steel carry-over tube per order.

This is an authentic part that is supplied directly from the original equipment manufacturer for Char-Broil gas grills. The control knob controls the burners on and off functions as well as the heat controls. This part is made of plastic and is sold individually, though two are required for the unit. There are no tools required for this part, simply slide onto the shaft and twist to secure into place.

This leg extender is a genuine Char-Broil replacement part. It is used for a variety of models of grills. This extender can be attached to the leg of a grill in order to adjust the height. It should be replaced if it is missing, cracked, or broken. This part is made of plastic and sold individually.

This part is an OEM from Char-Broil. The f/temp gauge bezel is fitted onto the grill lid, securing the temperature gauge. This metal item is sold individually. Pliers may be required for making the replacement.

This is an Original Manufacturer Approved replacement part used on certain Char-Broil Grills. This item is made out of Metal and it is Sold Individually. This support assembly holds the 6" X 6" burner tent over the burner. Depending on your model, your grill takes two or three of these tents.