463841804 Char-Broil Grill - Overview

This vaporiser bar is a genuine Char-Broil replacement part. It is supplied from original equipment manufacturer for use with gas grills. Bars are designed to redirect grease away from the burner tubes. This would greatly cut down on flare ups. An extra benefit of these bars is that they help add extra flavor to your food. Unfortunately, ...Read moreover time bars might begin to rust due to a combination of heat and moisture. This metal vaporizer bar is sold individually.

This replacement temperature gauge is specially designed for use with Char-Broil grills. It is an authentic OEM sourced item, not an aftermarket equivalent. This gauge is used to measure the temperature inside the grill. This part is made from durable metal and it is sold individually. Please note, the wing-nut and the washer to secure it are both included in this assembly. Dial reads 50 - 700 degrees.

This cooking grate is a genuine Weber replacement part that is specially manufactured for use with gas grills. It used to support the food over the burners providing for the best grilling experience. It is advised to clean it after each use to prevent rusting which normally is caused by the heat and moisture from the left over food. This cooking grate made from durable metal and it is sold individually.

This is an authentic OEM replacement burner and electrode assembly designed for Char-Broil gas grills. Burners are designed to distribute gas evenly to create a cooking area. This assembly is made out of stainless steel and it is sold individually. No tools needed to replace this burner. • Make sure the gas tank is disconnected • Di...Read moresconnect the electrode • Remove burner from the valve • Install the new assembly • Re-connect electrode and test the grill

This leg extender is a genuine Char-Broil replacement part. It is used for a variety of models of grills. This extender can be attached to the leg of a grill in order to adjust the height. It should be replaced if it is missing, cracked, or broken. This part is made of plastic and sold individually.

This part is an OEM from Char-Broil. The f/temp gauge bezel is fitted onto the grill lid, securing the temperature gauge. This metal item is sold individually. Pliers may be required for making the replacement.

The is an original Char-Broil replacement part manufactured for use with outdoor grills. This warming rack attaches to the sides of the lid and fire box. The warming rack pivots when the lid is raised. For grills with two racks, this is the lower of the two and is sold individually.