463251512 Char-Broil Grill - Overview

This is a genuine Char-Broil replacement part, it is sold individually. This is the part of the Grill that the flame is coming from on your Gas Grill. Depending on your grill you may have 3 or 4 of these. To connect these to your grill, place the flat side of the Burner in the rear side of the firebox in the slots provided. The front of t...Read morehe burner will connect to the Electrode W/ Wire/Collector. They will connect to the Hose Valve Regulator, and then the Control Knobs will be attached, so the flame can be controlled. This part includes one threaded pin and one cotter pins.

This is a genuine OEM replacement part for a Char-Broil Outdoor Stove. The grease tray is designed to catch grease drippings from food as it cooks. Before replacing this part make sure the stove is completely cooled down to avoid any possible injury. This part is made of metal with a grey powder coat finish. It is a separately sold replacement part.

This is an authentic OEM replacement part that is supplied directly from Char-Broil for use with a gas grill. The knob is used to control the temperature and intensity of the flame. This part does not require any tools simply connects to the burner valve. This part is made of chrome and plastic and is sold separately.

This is a genuine manufacturer sourced replacement parts designed for use with Char-Broil gas grills. The purpose of a heat tent is to direct grease and drippings away from the burner tubes. This will greatly cut down on flare ups. Tents will normally begin to rust due to the combination of heat and moisture. This item is made out of steel with porcelain coating and it is sold individually.

This is a manufacturer approved replacement part designed for use with Char-Broil gas grills. This item is made out of metal and it is sold individually. The carryover tube provides support for the burners, and carries the flame from one burner to the next. They also help to secure the burners in place. Over time, your carryover tubes may...Read more rust or warp. This would be the time to replace them. This assembly includes two (2) cotter pins.

This thermometer/ temperature gauge is a genuine manufacturer sourced replacement part. It is specially designed for use with Char-Broil grills. It can be used to measure temperature inside the grill. This part is made out metal and it is sold individually. It does include a wingnut that helps to secure it to the unit. Dial reads 150 - 650 degrees. No tools would be needed to replace this item.

This locking caster is sourced from the original equipment manufacturer for use with outdoor grills. It consists of a wheel, with a diameter of 3 inches, and a metal bracket that allows for easy transportation and positioning. It also includes a locking mechanism that prevents unintentional movement of the grill. Over time, the caster may...Read more break, corrode, or fall out of alignment, thereby causing instability, failure of the locking system, and potential accidents. The caster will also need to be replaced if it is jammed or stripped. To replace a defective caster, prop the grill up and use a wrench or screwdriver to turn and remove the caster mounting bolt. Remove any dirt and debris in the area and align the new caster with the mounting hole. Turn the caster until it is firmly locked in place to complete the repair.

The sideburner burner goes next to the sideburner. It is an authentic OEM sourced item which is specially produced for use with Char-Broil grills. This item is available as an individual replacement part. A screwdriver may be helpful when replacing this item. This part may become broken and will need to be replaced.

This is an authentic replacement part manufactured for use with Char-Broil outdoor grills. The rubber bumpers are used with the side burner lid to prevent damage to the self or lid. This rubber bumper is available as an individual replacement part.

This replacement button is a genuine OEM supplied item that is specially produced for Char-Broil grills. It is used to secure the battery in the electronic ignition module. Please note this item includes one black plastic button with a metal spring.