463241313 Char-Broil Grill - Overview

Genuine Char-Broil replacement part, this item is sold individually. It includes the igniter and two 26

OEM Rolled Stainless Steel Emitter is sold individually. This is the emitter tray only designed to be paired with a cast iron cooking grate part 80021355. Dimensions are approx. 18-1/4 X 8-7/8" Part is 5/8" Thick. If the part is heavily rusted or damaged it needs to be replaced.

This is a genuine Char-Broil replacement part, it is sold individually. This is the part of the Grill that the flame is coming from on your Gas Grill. Depending on your grill you may have 3 or 4 of these. To connect these to your grill, place the flat side of the Burner in the rear side of the firebox in the slots provided. The front of t...Read morehe burner will connect to the Electrode W/ Wire/Collector. They will connect to the Hose Valve Regulator, and then the Control Knobs will be attached, so the flame can be controlled. This part includes one threaded pin and one cotter pins.

This flame tamer also known as heat tent is a genuine manufacturer approved replacement part. It is sourced directly from original manufacturer for use with gas grills. Heat tents help to direct grease and drippings away from the burner tubes. This will help to reduce flare ups tremendously. Grill parts will rust in combination of heat an...Read mored moisture, that is why it is important to clean the grill after each use. Includes one (1) metal flame tamer per order. No tools needed to replace.

This is a Genuine Manufacturer Approved Control Knob used on Char-Broil Gas Grills. It helps to control your Burners. This part is made out of Plastic and it is Sold Individually. Replacing this part does not require any tools, this Knob fits over the Regulator Shaft. Please note Bezel is Sold Separately.

This is a genuine OEM replacement part for a Char-Broil Outdoor Stove. The grease tray is designed to catch grease drippings from food as it cooks. Before replacing this part make sure the stove is completely cooled down to avoid any possible injury. This part is made of metal with a grey powder coat finish. It is a separately sold replacement part.

This stainless steel cleaning tool is an OEM sourced directly from Char-Broil. This tool was designed to scrape cooked on food or grease from the grates of the grills listed below. Using this tool to maintain the cleanliness of the grill will extend the life of the grates. One item is included per order.

This authentic OEM sourced replacement part is specially designed for Char-Broil grills. This cooking grate is made from durable cast iron with black porcelain coating and it is sold individually. Cooking grate provides a stable cooking area for grilling the food.

This is an authentic manufacturer-supplied replacement part that is specially made for Char-Broil grills. The carry-over tube provides support for the burners and carries the flame from one burner tube to the next. Over time due to a combination of heat and moisture tubes may begin to rust or warp eventually requiring replacements. One hi...Read moregh-quality stainless steel carry-over tube with two clips to secure it are included. Check the diagrams of your model for the exact location and the correct installation of this component. You may require pliers to remove and secure the clips that secure the flame carryover tube.

This item is a genuine Char-Broil replacement part that is intended to be used with outdoor gas grills. The metal rail attaches to the bottom side of the firebox and is used to mount the grease tray to catch food drippings. The left rail is priced as a single replacement part.

An authentic manufacturer-sourced item that is specially designed for use with Char-Broil grills. This is one of the rails used to support the grease tray. It is a high-quality component which is made of durable metal and it is sold individually, please note the hardware to secure it is sold separately.