46163 Char-Broil Grill - Overview

This replacement grease cup is specially designed for use with Char-Broil grills. It is an authentic item that is sourced directly from original equipment manufacturer. The purpose of this tray is to collect the grease and other food particles from the food you are cooking. After each use it is recommended to clean this part with soap and...Read more water to avoid rusting. This item is made out of metal and it is sold individually. Please note, the grease cup clip/holder is sold separately.

This is an authentic replacement part manufactured for use with Char-Broil outdoor grills. The chrome plated bezel is the plate beneath the control knobs that regulate the fuel that is sent to the burners. This bezel is available as an individual replacement part, please see model diagram for associative parts.

It is an authentic OEM supplied replacement item that is specially produced for use with Char-Broil grills. This is the clip that helps to secure the grease cup which is sold separately. Please note this durable metal item is sold individually.

This is an individual plastic wheel compatible with various models of outdoor grills. This wheel attaches to an axle rod at the bottom of the grill assembly, allowing you to move it around. If you find your grill difficult to move and notice that the wheel(s) do not rotate or move smoothly due to damage or warping, you will need to replac...Read moree this wheel. Consider ordering multiple wheels if you find that more than one is not moving properly. This wheel measures approximately 6 inches in diameter and has a 1 1/16-inch outer diameter and 3/8-inch inner diameter bearing. To replace this wheel, you only need to remove the pin that secures it to the axle rod. Then, you can slide off the old wheel and install and secure the new wheel in place.

This piezo ignitor button is an OEM part direct from Char-Broil. Compatible with many grills, this metal and plastic component is sold individually. The piezo ignitor button creates the needed spark to light the grill burner. You may need a screwdriver and pliers for the repair.

This replacement carryover tube is an authentic OEM sourced high quality item that is specially designed for Char-Broil gas grills. The purpose of the carryover tube is to provide support for the burners, and carry the gas from one burner to the next. Over time in the combination of heat and moisture the tubes may begin to rust or warp ev...Read moreentually requiring replacement. This item includes one durable stainless steel carryover tube and two metal cotter pins that are used to secure it.

This item has been sourced from the original manufacturer to be used with outdoor gas grills from Char-Broil. The metal bezel attaches to the control panel and is used to provide spacing and to support the burner control knob. This item is also used to provide an indication of the size of the flame. This part has been priced as a single item.

This handle is an authentic replacement part sourced straight from the original equipment manufacturer. It is compatible with over 100 models of grills. This handle is made of plastic and it should be replaced if it is damaged. It is sold individually.

This is a genuine manufacturer-sourced component which is specially designed for use with Char-Broil grills. It is an identical replacement for a missing or a faulty locking caster that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct installation of this part. Keep in mind this high-quality caster is sold individually. Note, the