455E (TRIOBRAKE) Husqvarna Chainsaw - Overview

Designed for use in various chainsaws, the E-Ring secures the pivot pin, which holds the handguard. It is an authentic OEM replacement part made of durable black metal and sold individually, not as part of a kit or assembly. When this part malfunctions, you may notice the handle or handguard is loose. At which point, it will need to be ...Read morereplaced. To complete this repair, you will need a pair of pliers. Customers rate this repair as Easy.

This is a genuine OEM approved replacement screw made for Husqvarna chainsaws and brush cutters. It is a standard hardware which has multiple uses based on your equipment. Please refer to diagrams for correct application. It is made out of metal and it is sold individually. You would need a torx screwdriver to install or remove this screw.

This replacement screw is a high quality hardware that is commonly utilized on Husqvarna chainsaws. It is an authentic OEM item that has multiple uses, for correct location and application of this screw please make sure to check appropriate diagrams. One durable metal hex socket head screw is included per order.

It is an authentic OEM replacement part that is specially designed for Husqvarna chainsaws. This is the left part of the handle that houses the trigger switch. It is made from durable high quality plastic and it is sold individually, please note the hardware to secure it is sold separately.

It is an authentic OEM sourced item which is specifically produced for use with Husqvarna and Jonsered chainsaws. The spring fits onto the knee joint and is made of metal. During installation, a wrench set, a screwdriver, and a set of pliers may all be needed to help replace this part. It will need to be replaced if it becomes broken or stretched. Keep in mind that this part is sold individually.

This throttle trigger is an original part from Husqvarna. The plastic throttle is secured to the spring in the throttle lock, allowing the operator to control the amount of fuel going to the chainsaw engine. A screwdriver, Allen wrench and socket set are often needed for the removal and installation. The throttle trigger is sold individually.

This is an authentic Husqvarna replacement part that has been sourced from the original manufacturer to be used with chainsaws. The metal spring is part of the rear handle and is used to provide tension on the trigger to keep the trigger pressed outward. This item is available as an individual replacement part.

This item is priced individually. The throttle lock attaches to the rear handle and is made of plastic. It is to be used in chainsaws. This part will need to be replaced if it breaks and a screwdriver may be needed during installation. This is a Husqvarna replacement part directly sourced from the manufacturer.

This is a genuine Husqvarna part that is OEM sourced to ensure a high level of quality. This item is intended to be used with chainsaws. The guide bushing is used to secure the cover to the chain brake housing assembly. This item is sold as an individual replacement part.

This part is available as an individual replacement even though two may be needed. The movement limiter connects to the front handle. During replacement, it may require a nutdriver, a wrench set, and a screwdriver to help install this part correctly. It is made of a hard rubber and will need to be replaced if it becomes broken. This is a genuine Husqvarna and Jonsered replacement part used in compatible chainsaws.