4204 - Overview

This part is located beneath the element and catches any spills.

This burner bowl is also known as a burner drip bowl or burner drip pan, and is designed for use with your cooktop or range. It is black in color and is approximately 6 inches in diameter. It can be found beneath the element and catches spills. If your old burner bowl is damaged or missing, you may need to replace it with this part.

The bearing seal, also known simply as the seal, is a special seal for the bearings in your tiller. It attaches in the tiller housing, with the bearing and shaft, and over time it can become damaged due to fatigue and general wear. This part is made of rubber, is black in color, and is sold individually. Repairing the bearing seal will ...Read moregenerally be a medium-difficulty job, one that requires a screwedriver, socket set, wrench set, and hammer.

This is a genuine Oster replacement part, it is sold individually. This is the new round Jar design. If you have the old style Jar, you will need to order the part numbers, 124462-000-090 Jar Cover & 050613-002-089 Filler Cup.

The 031014-104-000 Agitator is sold individually. The Agitator Assembly (Or Blade Assembly) is the part of the blender that chops, blends or mixes the product that is put into the blender jar. After time the blades will become dull or break or the spline that is attached to the shaft may wear out. When replacing the Agitator it is advisab...Read morele to inspect the Sealing Ring, which is in between the agitator and the jar for cracks and if it has been compressed too much, which will cause it to leak from the bottom.

This is an original part sourced directly from the manufacturer. This 13-ounce can of red spray paint was designed for use on a variety of Troy-Bilt and MTD equipment and is an identical match for paint needed for touch-ups. One can is included per order.

Receptacle only. No wires are included. Sold individually.

This item is made of metal and is sold individually. The runner attaches to the housing assembly. A socket set may be necessary during the installation of this part. Over time this item may break and will need to be replaced. It is a genuine OEM sourced part which is specially designed for use with Troy-Bilt and Bolens snowthrowers.

This OEM Top Locknut measures 5/16x18, is made of metal, and it isused to secure parts in place and prevent backing out from vibration. Replacing this part varies in difficulty depending on the part it is securing and the equipment in question, but it is generally an easy job according to our customers. Installation requires a wrench or socket.

The manufacturer-approved Ratchet Pawl (Starter Pawl) comes in a set of two (2). This part attaches inside the recoil assembly, and is used to engage the flywheel. if broken due to wear/damage it will have a hard time engaging the fly wheel, making the engine harder to start, and should be replaced. Installation is rated as "Easy" by cust...Read moreomers, and will require a screwdriver, pliers and nutdriver. Refer to your make, model and diagram to ensure this is the correct part for you.This model is plastic and comes in white.