41AS2HBC983 MTD Leaf Blower / Vacuum - Overview

This is an authentic Craftsman replacement part that has been sourced from the original manufacturer to be used with trimmers and blowers. The gasket is used to seal the connection between the carburetor and the air cleaner assembly. It is recommended to replace gaskets when servicing the motor to ensure proper seals when the parts are reassembled. This item is available as an individual replacement part.

This is a manufacturer approved O-Ring designed for lawn and garden equipment. This is the O-Ring that provides an Air Tight seal between Carburetor and Cylinder Head. If doing maintenance on carburetor it is recommended to replace the O-Ring instead of re-using the old one. Over time rings and seals tend to dry out and would no longer provide proper seal compromising engines performance.

This is a foam air filter designed for use within various models of outdoor power equipment like trimmers and leaf blowers. This foam filter measures approximately 3-inches in length and fits within the air filter assembly to prevent contaminants from entering your equipment. Air filters commonly build up with dust and dirt over time, and...Read more will need to be replaced every so often, and regularly inspecting them for build ups can reduce the amount of extra maintenance that is required. If your air filter is clogged, it will lead to worse performance from your equipment, like difficulty starting or not starting at all, and can even damage the carburetor and engine. To replace the air filter, remove the cover for the air filter housing, and remove and dispose of the old filter. Rub a small amount of oil into the new filter before installing it and securing the air filter cover.

This is an OEM insulator assembly that is used to protect the carburetor from engine heat and features various seals and hardware made of plastic, steel and rubber. It fits in between the carburetor and cylinder to prevent excessive heat from affecting the performance and operation of the carburetor. It is recommended that you use protect...Read moreive gloves, a screwdriver, and other tools for the replacement process, so check your model for what tools you will need for installation.

This is a genuine replacement part manufactured for use with leaf blowers. The plastic nozzle funnels the air exiting the blower tubes. Since the nozzle is at the end of the blower tubes it can make contact with the ground or other surfaces which can wear down the nozzle. This nozzle is available as an individual replacement part, please see model diagram for any additional parts.

This is an authentic part that is supplied by the original manufacturer for use with lawn and garden equipment. The flywheel has magnets on its side that create an electric charge as the magnets pass the ignition module. The electric charge is sent to the spark plug to fire the air-fuel mix in the cylinder. The flywheel fits on the cranks...Read morehaft by a key that aligns with a keyway on the crankshaft, this allows for proper firing timing. If the key on the flywheel is broken it can cause misfires or will not start at all. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality flywheel assembly is made of durable metal and is sold individually.

This upper tube is sourced from the original manufacturer for use in blowers. It is a plastic, cylindrical tube that is connected to the blower nozzle on one end and the lower tube on the other. Its purpose is to facilitate the flow of pressurized air through the blower nozzle. If the upper tube becomes cracked, clogged, or falls out of a...Read morelignment, it can result in reduced airflow and inconsistent blower performance. Replacing the upper tube is an easy repair. Simply twist and pull it off the blower and insert the new one in its place. Insert and twist the new tube until it is locked in position.

This is an authentic Craftsman replacement part that has been sourced from the original manufacturer for use with blowers. The plastic cover assembly includes the screws and the foam filter that is used to cover the base to prevent contaminants from entering the engine's intake. This part kit is sold complete and the kits are sold individually.