414500K Jet Table Saw - Overview

This pad is an OEM part direct from Powermatic. Constructed of soft material, this item is compatible with several band saw devices. The pad is fitted onto the fence, providing protection from abrasion. The pad is sold individually. No tools are required for the replacement.

It is a genuine manufacturer-supplied part that is made for use with Jet and Wilton vertical bandsaws. The hinge-upper is a special component which helps to adjust the blade tracking. If the part is missing or is damaged, this will provide an identical replacement for the original part that was installed on a new unit. One durable metal h...Read moreinge-upper is included. Check the owner's manual and the appropriate diagram for your model to ensure the proper repair procedure. A wrench set might be needed to remove the old component and secure the new one.

This is an authentic replacement wheel tire for Wilton and Jet band saws. It is supplied directly from original equipment manufacturer and it is sold individually. Its purpose is to provide a stable grip for the saw blade. When attaching the new tire on a band saw wheel, it may appear too be too small, however it really is not. These tire...Read mores when new are typically approximately two (2) or more inches shorter than the old tire. Tires are supposed to fit very tightly against the bad saw wheel. As the tire ages, the rubber hardens allowing for the blade to slip. Note, it is a good idea to put the new tire in hot/warm water to heat it up just enough to make it pliable enough to stretch. Its advised to have two people in the stretching process.

This part is available as in individual replacement. The metal cutting saw blade goes around the upper wheel and the lower wheel. While replacing this part a wrench may be needed. If this part becomes broken it will need to be replaced. This is a replacement part directly sourced from the manufacturer for use in bandsaws made by Wilton and Jet.

An authentic item that is supplied directly from the original equipment manufacturer for use with Wilton and Jet band saws. It is a high-quality replacement for a missing or faulty switch which controls the on/off function of the unit, over time component may wear out and begin to fail eventually requiring a replacement. Keep in mind this durable switch is sold individually.

This is an authentic replacement part manufactured for use with verticle band saws. The special set screw is commonly used to secure the carbide blade guide to the support bracket. This set screw is available as an individual replacement part, please note two set screws may be required.