40353 Dynabrade Bandfile - Overview

It is a genuine replacement o-ring which is supplied by the original equipment manufacturer for use with Dynabrade power tools. This item is utilized to provide an air-tight seal between connected parts, please make sure to check appropriate diagram of your model for the correct use and location of this component. Over time o-rings tend t...Read moreo deteriorate and crack eventually requiring replacement to maintain peak performance. It is a high-quality part that is made of durable rubber material and it is sold individually.

This is an authentic OEM part. The metal screw is made for use with several abrasive belt tools. The screw secures the belt guard, and is sold individually. A Phillips screwdriver is needed for the installation.

It is a genuine OEM sourced replacement screw which is specially produced for use with Dynabrade power tools. This part is a standard hardware which has multiple applications depending on the model of your unit, please make sure to refer to the appropriate diagrams for the correct location and use of this item. It is a high-quality hex socket head screw which is sold individually.

This genuine OEM replacement part is used in a variety of grinders and sanders, so it is wise to cross reference your Model Number. The purpose of this is to ensure a proper fit so that your machine can run safely. The hardware required to secure this part into place will be sold separately.

This is an authentic OEM component from Dynabrade. The valve stem is constructed of durable metal, and is compatible with many sander and grinder power tools. This part assists with fastening the speed regulator into the throttle lever assembly. The valve stem is sold individually. A wrench set, screwdriver and pliers are often necessary ...Read morefor the proper replacement. Refer to the owner's manual for additional repair instructions.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.