392 (Type 1) Porter Cable Sander Polisher - Overview

This Pad is designed for the "Adhesive Backed" Sanding Pads.rnThe (PSA) sander pad is a direct replacement for many Dewalt orbital sanders. It is a genuine Dewalt part, not off-brand. It features a foam body attached to a metal backing plate. It also has a sturdy smooth style bottom for use with sticky adhesive sandpaper. This pad does no...Read moret have vacuum holes. It is 5" in diameter. This pad is compatible with the Dewalt sanders listed below. This pad is interchangeable with sanders fitted with 5" hook-and-loop pads. If you prefer to fit your sander with hook-and-loop sandpaper instead of adhesive, you will need the hook-and-loop pad listed under "Related Products" below. Model compatibility is the same.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

It is a high-quality OEM part that is specially made for Porter Cable, Black and Decker and DeWALT power tools. The receptacle is designed to safely secure and connect a wire. It is an identical replacement for a faulty or a missing part that was installed on a new unit. To ensure the correct application, refer to the appropriate diagrams...Read more of your model. Note, this high-quality receptacle is made of durable metal and is sold individually. You will need a screwdriver to take the housing apart when replacing this component.

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-ring failure. The most common among power tools are: • The O-ring has ragged, tattered edges. These are commonly caused by pressure ...Read morespikes which shear off tiny "bites" from the O-ring, or caused by clearance gaps. • One or both sides of the O-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit, or is too smooth to allow lubrication. • The O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • The O-ring has a pitted or cracked surface, and is often flattened on both sides. Caused by temperature exceeding O-ring capacity. • The O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays, and air pollution. Excessive seal stretching (greater than 5%) causes similar cracking.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This torx screw is specially manufactured for use with a variety of power tools. It is an authentic OEM sourced item, not an aftermarket equivalent. This piece of hardware has multiple uses depending on the tool. Please make sure to check appropriate diagrams for correct location and use of this item. You will need a torx screwdriver to tighten or loosen this screw. It is sold individually, (1) screw per order.