This is a genuine Weber part used with Genesis and Spirit grills. This assembly includes the hose and regulator as well as the manifold. The regulator controls the release of gas from the tank into the fuel line to the manifold. The manifold then directs the fuel to the burners. It includes installation hardware and written instructions.
This is a manufacturer sourced replacement thermometer designed for use with Weber grills. It can be used to measure temperature inside the grill and the temperature of the food. This part is made out metal and it is sold individually. Wingnut is included. Dial reads 150 - 600 degrees.
This is a genuine Weber replacement part that is specially designed for use with gas grills. This bottom tray will catch the grease drippings providing and easy way to keep your grill clean and ready for service. This is a black porcelain enameled steel tray that is sold individually.
This is a genuine Weber replacement part manufactured for outdoor gas grills. The metal tray rails support the drip pan, and each rail will mount using one screw. This bottom tray rail set will come with two screws, and two rails. The sets are sold individually.
This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.
This is an authentic Weber replacement part used with grills. This stainless steel kit includes two handles and four screws. These handles sit on both of the front doors of the grill. The handles are attached to the front over two pre-drilled holes; the screws are installed through the inner back of the door.
This is a genuine manufacturer sourced replacement part designed for use with Weber gas grills. It helps to control your burners. Replacing this part does not require any tools, this knob fits over the regulator shaft. Please note bezel is sold separately. These control knobs are made out of plastic and they are sold in a pack of three (3).
Genuine Manufacturer Approved replacement Burner Tube Set designed for certain Weber Grills. Consists of 1 crossover tube and 3 burner tubes. These tubes are made out of stainless steel. They allow grill temperature to be properly maintained. Easy to install with included hardware and instructional guide.