3700B Makita Laminate Trimmer - Overview

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually re...Read morequire replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

This is a genuine OEM sourced part which is specially designed for use with Makita equipment. It is an identical replacement for a missing or faulty wrench that was originally included with a new unit. Please make sure to refer to the owners manual for the correct location and application of this item. Keep in mind this high-quality wrench is made of durable metal and is sold individually.

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

This item is a genuine Makita part that has been sourced from the original manufacturer to be used with trimmers, circular saws, sanders, routers, nailers, reciprocating saws, laminate trimmers, and planers. The flat washer is used with different types of power tools and the application of the washer can vary based on the model of the equipment. This item is available as an individual replacement part.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

This genuine manufacturer-sourced part is specially designed for Makita power tools. It is an important component which provides a tight seal between connected components. Unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. To ensure the correct repair procedure, refer to the appropriate...Read more diagrams for your model. Note, this high-quality insulation washer is made of durable material and is sold as an individual item. A screwdriver will be needed to take apart and reassemble the tool when performing this repair.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This is a Ball Bearing that is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwise spin and rub against each other. The balls or rollers take the load and spin, distributing the weight evenly while the minimal co...Read morentact area of the balls reduce friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This replacement adjustment knob/screw is a genuine Makita part. It is supplied from original equipment manufacturer for use with belt sanders/trimmers. While the belt is running, use the adjusting knob to center the belt tracking. Failure to do so can result in frayed belt edges and wear on the sander frame. It is made out of metal with a plastic head/grip. This item is sold individually.

This is a genuine item that is supplied by the original equipment manufacturer for use with Makita equipment. It is a high-quality replacement for a missing or damaged screw that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hard...Read moreware. Keep in mind this high-quality thumb screw is made of durable metal with a plastic grip and is sold individually.

Genuine Makita replacement part. This pan-head phillips screw includes a washer. It is sold individually.