36-944 (Type 1) Delta Table Saw - Overview

This is a manufacturer sourced replacement part designed for use with table saw fences. It helps the fence/rail to slide smoothly. It is made out of plastic and it is sold individually. No tools are required to replace it. You may need pliers to take out the old pad.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Delta and Biesemeyer table saws. This is an identical replacement for a missing or a worn glide pad that attaches to the fence. It helps to reduce friction the fence is adjusted. It is made of high-quality material and is sold as an indivi...Read moredual component. Note, the hardware to secure it is sold separately. Make sure to check the owner's manual and the appropriate diagrams for your model for the correct application.

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

This arbor and flange assembly is designed for right-tilt table saws and plays a key role in securing the saw blade for smooth, accurate, and safe cutting. Made from durable metal, it helps reduce vibration and restore proper blade alignment when the original arbor becomes worn or damaged. This assembly is typically sold without bearings ...Read moreand is commonly used during repairs or partial rebuilds. Be sure to confirm your saw’s configuration and compatibility before purchasing to ensure proper fit and performance.

This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on ...Read morethe tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

The key attaches to the shaft and is made out of metal. This item is available individually. This is a genuine replacement part sourced from the original manufacturer for use with saws, drills, jointers, and shapers made by Delta. When replacing this part a set of pliers might be required during the installation process. It will require replacing if it becomes bent or broken.

This replacement belt is specially designed for Delta table saws. It is a genuine OEM part, not an aftermarket imitation. This is the main belt that helps to spin the saw blade. Make sure to clean drive pulleys before installing the new belt. This will help to ensure top performance with your new belt. Inspect this belt periodically and r...Read moreeplace it when worn or stretched. This part is made out of durable rubber and it is sold in a pack of three.

This is an authentic Delta replacement part, sourced from the original manufacturer for use with table saws. The self-adhesive tape measure is commonly placed on the front rail and used to indicate the size of the wood that is to be cut. This item is available as an individual replacement part.

This is available as an individual replacement part. The keps nut attaches to the bracket and is made of metal. During replacement, it may require a wrench set to help install this item correctly. It will require replacing if it becomes broken. This is a genuine Delta replacement part used in compatible table saws, unisaws, and band saws.

This replacement insert is specially designed for Delta table saws. It is a genuine OEM sourced item, not an aftermarket equivalent. These inserts help to reduce splintering on the cuts and prevent thin slices of wood from jamming in between the blade and the plate.