36-943 (Type 1) Delta Table Saw - Overview

This is a manufacturer sourced replacement part designed for use with table saw fences. It helps the fence/rail to slide smoothly. It is made out of plastic and it is sold individually. No tools are required to replace it. You may need pliers to take out the old pad.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Delta and Biesemeyer table saws. This is an identical replacement for a missing or a worn glide pad that attaches to the fence. It helps to reduce friction the fence is adjusted. It is made of high-quality material and is sold as an indivi...Read moredual component. Note, the hardware to secure it is sold separately. Make sure to check the owner's manual and the appropriate diagrams for your model for the correct application.

This is a genuine replacement part for Delta table saws and Biesemeyer fences. The cursor connects to the board kit. It is made out of plastic and will need to be replaced if it becomes broken. A screwdriver may be needed during the replacement of this part. This item is sold individually.

This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on ...Read morethe tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This genuine manufacturer-sourced replacement washer which is specially designed for use with a variety of equipment. It helps to distribute the pressure evenly between connected parts, this is a standard hardware which has multiple applications depending on the model of your equipment, please refer to appropriate diagrams for the correct...Read more location and use of this part. This part is a high-quality washer which is made of durable metal and it is sold individually.

The key attaches to the shaft and is made out of metal. This item is available individually. This is a genuine replacement part sourced from the original manufacturer for use with saws, drills, jointers, and shapers made by Delta. When replacing this part a set of pliers might be required during the installation process. It will require replacing if it becomes bent or broken.

This authentic manufacturer sourced replacement starter motor which is specially produced for use with Delta table saws. The starter motor provides an initial motion to engage the flywheel to start the engine. Please note this high-quality item is sold individually.

This replacement belt is specially designed for Delta table saws. It is a genuine OEM part, not an aftermarket imitation. This is the main belt that helps to spin the saw blade. Make sure to clean drive pulleys before installing the new belt. This will help to ensure top performance with your new belt. Inspect this belt periodically and r...Read moreeplace it when worn or stretched. This part is made out of durable rubber and it is sold in a pack of three.

This is available as an individual replacement part. The keps nut attaches to the bracket and is made of metal. During replacement, it may require a wrench set to help install this item correctly. It will require replacing if it becomes broken. This is a genuine Delta replacement part used in compatible table saws, unisaws, and band saws.