36-431 (Type 1) Delta Table Saw - Overview

This is a manufacturer sourced replacement part designed for use with table saw fences. It helps the fence/rail to slide smoothly. It is made out of plastic and it is sold individually. No tools are required to replace it. You may need pliers to take out the old pad.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Delta and Biesemeyer table saws. This is an identical replacement for a missing or a worn glide pad that attaches to the fence. It helps to reduce friction the fence is adjusted. It is made of high-quality material and is sold as an indivi...Read moredual component. Note, the hardware to secure it is sold separately. Make sure to check the owner's manual and the appropriate diagrams for your model for the correct application.

This is a genuine replacement part for Delta table saws and Biesemeyer fences. The cursor connects to the board kit. It is made out of plastic and will need to be replaced if it becomes broken. A screwdriver may be needed during the replacement of this part. This item is sold individually.

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on ...Read morethe tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is available as an individual replacement part. The keps nut attaches to the bracket and is made of metal. During replacement, it may require a wrench set to help install this item correctly. It will require replacing if it becomes broken. This is a genuine Delta replacement part used in compatible table saws, unisaws, and band saws.

This replacement insert is specially designed for Delta table saws. It is a genuine OEM sourced item, not an aftermarket equivalent. These inserts help to reduce splintering on the cuts and prevent thin slices of wood from jamming in between the blade and the plate.