This is an original Bissell part. This Solenoid Valve is used in many models of Bissell Carpet Cleaners. When powered, this valve allows the flow of water at the press of a button or the pull of a trigger. This part should be replaced when water will not flow or when it won't stop flowing. When replacing the Valve, double check the condit...Read moreion of the Tubing (part number B-203-6819) making sure that it is free of cracks and splits. Tools Used: • Philips Screw Driver • Needle Nose Pliers
This is a genuine OEM sourced replacement part that is specially produced for use with Bissell carpet cleaners. It is designed to keep the water in the tank. This item includes one plastic tank cap and the flexible straw.
This is a Genuine Bissell geared Motor belt, it is sold individually. When replacing Left Belt it is recommended to replace the Right Belt part #B-203-6804 as well for best operation. The belts on vacuum should be checked periodically. If belts are worn or stretched they need to be replaced to avoid potential damage to the unit.
Genuine Bissell supplied replacement part for a variety of Carpet Cleaners. This item is sold individually. When replacing Right Belt it is recommended to replace the Left Belt as well for best operation. The belts should be checked periodically. If belts are worn or stretched they need to be replaced to provide best performance.
The autoload receiver goes between the swivel arms and the geared belt. This item is made out of plastic and is available individually. It is a genuine replacement part sourced from the original manufacturer for use with carpet cleaners made by Bissell. When replacing this part a screwdriver might be required during the installation process. It will require replacing if it becomes broken.
This is an authentic Bissell replacement part manufactured for use with lift-off deep cleaners. The hose assembly is used with the cleaning attachments to clean hard to reach areas. This hose assembly is sold as an individual replacement part, please see model diagram for associative parts.
This is an authentic replacement part sourced directly from the manufacturer. The pod duct gasket assembly is commonly found in Bissell cleaners. This part includes two flexible rubber gaskets, which are used to prevent leakage around components in the machine. You may require a screwdriver when replacing these parts.
This genuine OEM brush roll assembly designed for Bissell steam carpet cleaner. The spinning motion of the brush rolls picks up the dust and dirt from the floor. Over time bristles will wear out and would need to be replaced. It is made out of plastic and it is sold individually. To complete this part you would need a screwdriver. • R...Read moreemove the cover/housing • Remove old brush roller and secure the new one into place • Re-assemble and test the unit
This genuine OEM sourced replacement part is designed for Bissell steam carpet cleaner. This is the motor that turns the brushroller. This motor assembly includes one (1) geared pulley, one (1) washer, one (1) c-clip and two (2) wire terminals. To complete this repair you would need a screwdriver.